Engineering Commons^™

Sensitivity Analysis Of Geometry Changes In The Simulation Of Basilar Aneurysms, Paul Eserkaln

Theses and Dissertations

Computer simulation is a useful tool in the research and treatment of basilar aneurysms. Current technology allows researchers to create 3D models from cerebral vasculature in-vivo, allowing for the investigation of surgical options with minimal risk to the patient. The method used to construct these models overlooks smaller lateral arterial branches which are difficult to discern due to resolution limits of the imaging process. These lateral branches have minimal impact on the overall blood flow through the basilar artery, but they play a significant role in the health of the patient, so it is important to ensure sufficient blood will …

Monitoring And Modeling The Hydrological Performance Of Extensive Green Roof Systems, Joseph Seidl

Theses and Dissertations

Urban stormwater runoff causes many problems for watersheds located within large metropolitan areas, including such detrimental effects as flooding, erosion, pollution, and the increased risk of combined sewerage overflows. Increased amounts of impervious areas resulting from urban sprawl have also been shown to escalate stormwater flows, which exacerbates water management issues in these metropolitan areas. Water resource engineers have progressively turned toward green infrastructure to solve stormwater problems, and green roof systems represent one type of this green infrastructure. As of current, however, green roof systems are largely underused in as an effective stormwater management tool.

The major factor limiting …

Modeling The Feasibility Of Corn Stover Combustion As A Heat Source At Corn Ethanol Plants, Sulekha Tamvada

Theses and Dissertations

Alternative energy sources are of prime interest for most of the nations across the world. Rising fuel prices and depleting petroleum reserves are of serious national and global concern. Bio-fuels if proved feasible for larger scale implementation could become the ideal breakthrough in easing the extensive dependence on fossil fuels and retaining the current engine technology of fossil fuels. Current methods of producing bio-fuels rely heavily on the consumption of non-renewable energy in the production process. Therefore, it is desirable to find renewable alternatives to these non-renewable energy sources.

Although bio-mass based fuels have been tested and proven to be …

Effect Of Mechanical Abrasion On Oil/Water Contact Angle In Metals, Simin Salam Tabrizi

Theses and Dissertations

In this study the oil/water angle for brass, aluminum, hastelloy and 316 stainless steel was experimentally studied as a function of surface roughness. Samples were mechanically abraded by sandpaper in the way that all the scratches were parallel. Surface roughness was measured by profilometer, Nano-Indenter, and Atomic Force Microscope (AFM). The relationship between sandpaper particle size and surface roughness for all four metals was established. The highest surface roughness obtained for steel 316 ground by 180 grit sandpaper (1.23µm) and the smoothest surfaces were achieved for brass and aluminum after grinding with alumina (0.03 µm).Then oil/water contact angles were measured …