Engineering Commons^™

An Investigation Of The Response Of A Velocity Sensing Resonant Oscillator In An Inertially Operated Distance Meter, Howard F. Devaney

Electrical and Computer Engineering ETDs

It was the purpose of this study to investigate the response characteristics of a resonant mechanical oscillator utilized as a governor in conjunction with an inertial distance meter to sense velocity of a carrier. In order to initiate any desired event at a predetermined velocity of a vehicle (for example: fuel cut-off in a conventional liquid fuel rocket motor) it is often desirable to utilize a component requiring no external power for its operation. Such a component would be activated by inertial force and, by some means, integrate the force (or acceleration) with one respect to time and provide a …

The Rating Of A Power Type Transistor, Richard Lee Mann

Electrical and Computer Engineering ETDs

The purpose of this paper is to describe the test performed and present the results obtained in an attempt to establish the maximum permissible direct current and pulse ratings for the type of CTP-1003 (Clevite Transistor Products) power transistors under typical operating conditions. The manufacturer's specifications for the type of CTP-1003 power transistor are located in Appendix A.

The Dc Design Of Reliable Multistable Circuits, Richard H. Williams

Electrical and Computer Engineering ETDs

The reliability of a piece of equipment is a measure of its ability to function as intended. Equipment may malfunction in two different ways. It may fail catastrophically as a vacuum tube does when its heater opens; it may fail gradually as a vacuum tube does when its transconductance slowly falls to an unacceptable level over a period of time. It is not the intent of this paper to study catastrophic component failures, but rather to illustrate a technique whereby gradual failure of circuits can be minimized.

A Binary-To-Decimal Converter, Samuel D. Stearns

Electrical and Computer Engineering ETDs

This paper describes a device which electronically converts a binary number into its decimal equivalent. Such a device might be of use in digital computers, many of which use the binary number system, and also in similar machines, such as pulse code modulated data collectors.

The binary-to-decimal converter described here was designed specifically for use in Sandia Corporation's High-Speed Digital Recording and Data Handling System, which actually uses the Gray code rather than the binary number system. However, conversion from Gray to binary (see Appendix B) is simple, and a binary-to-decimal converter seems much simpler than a Gray-to-decimal converter.