Engineering Commons^™

Low-Cement Concrete Mixture For Bridge Decks And Rails, Soumitra Das, George Morcous Ph.D., Jiong Hu

Nebraska Department of Transportation: Research Reports

Right after construction, drying shrinkage of restrained concrete bridge decks and rails causes early-age cracking, insertion of water and chemicals, and corrosion of reinforcing steel that eventually leads to delamination and spalling of concrete. The main objective of this research is to control early-age shrinkage cracking by reducing cementitious material content in bridge deck and rail concrete mixtures. Several reduced cementitious materials concrete (RCMC) mixtures were developed by optimizing aggregate particle packing and conducting overall performance evaluation. This evaluation was carried out in three phases. The first phase investigated the feasibility of new RCMC mixtures by testing workability, compressive strength, …

Uhpc Decked I-Beam For Accelerated Bridge Construction, George Morcous, Maher K. Tadros

Nebraska Department of Transportation: Research Reports

Ultra-High-Performance Concrete (UHPC) is an excellent material for bridge construction due to its exceptional durability and superior mechanical properties. Several Departments of Transportations (DOTs), including NDOT, have limited the use of UHPC in bridge construction to joints and connections between bridge components due to the relatively high materials cost of commercially UHPC products. Recently, NDOT has sponsored a research project to develop a non-proprietary UHPC using local materials to reduce materials cost and ensure its availability to local contractors and precast producers. The project was completed successfully and an economical UHPC mix that satisfied all workability, durability, and strength requirements …

Phased Construction Bridges: Monitoring And Analysis For Traffic-Induced Vibration, Khalid Al-Kady, Christine E. Wittich, Richard L. Wood, George Morcous

Nebraska Department of Transportation: Research Reports

Phased construction is a common technique utilized to allow bridges to remain partially open to traffic throughout the construction process. The segment of the bridge deck that is constructed second cures under the effect of traffic-induced vibration transmitted from the adjacent bridge-deck segment, which is open to traffic. However, subjecting bridge decks to traffic-induced vibration during early-age curing raises concerns about the durability of the decks. The primary goal of this study is to generate a fundamental understanding of the transmission of traffic-induced vibration, the extent of degradation on phased construction bridge decks, and the impact of potential mitigation measures. …

Design And Detailing Of Cast-In-Place And Precast Concrete Approach Slabs, George Morcous, Mostafa Abo-Elkhier

Nebraska Department of Transportation: Research Reports

Approach slab is a structural concrete slab that spans from the backwall of the abutment (i.e. end of the bridge floor) to the beginning of the paving section. The purpose of the approach slab is to carry the traffic loads over the backfill behind the abutments to avoid differential settlement that causes bumps at the bridge ends. Cast- in-place concrete approach slab is the current practice in US with various spans, reinforcement, thicknesses, joints, and concrete covers. NDOT has observed premature cracking in a significant number of approach slabs, which could result in a shorter service life and costly repairs/replacements …

Application Of Internal Curing To Improve Concrete Bridge Deck Performance, Arman Abdigaliyev, Yong-Rak Kim, Jiong Hu

Nebraska Department of Transportation: Research Reports

Due to the relatively high cement content and low water-to-cement ratio (w/c) used, bridge deck concrete is prone to premature cracking. Internal curing has been found to greatly reduce the chance of premature cracking as well as concrete deterioration. This research project was intended to develop internally cured bridge deck concrete based on a local mix design in Nebraska. Four different lightweight fine aggregate (LWFA) as internal curing agents were evaluated, and their effects on fresh, mechanical, durability, and shrinkage properties of concrete were studied. To identify the most effective LWFA dosage for shrinkage reduction, different replacement rates of sand …

Development Of An Ndt Tool For In-Situ Assessment Of Prestress Loss, Bibo Zhong, Jinying Zhu, George Morcous

Nebraska Department of Transportation: Research Reports

The research objective is to develop a non-destructive testing (NDT) method to evaluate the prestress loss in prestressed concrete bridge girders using ultrasonic waves. The work principle is based on acoustoelastic effect - ultrasonic wave velocity varies with stress level in prestressed concrete. A self-reference test setup was proposed to measure wave velocity in two orthogonal directions (prestress and unstressed directions) in the girder. This setup will be able to reduce effects of material variation and temperature change.

The concept was first validated on small concrete specimens (cylinders and beams) in laboratory. A signal analysis algorithm was developed to reliably …

Feasibility Study Of Development Of Ultra-High Performance Concrete (Uhpc) For Highway Bridge Applications In Nebraska, Flavia Ribeiro Furtado De Mendonca, Mostafa Abo El-Khier, George Morcous, Jiong Hu

Nebraska Department of Transportation: Research Reports

Ultra-high performance concrete (UHPC) is a new class of concrete that has superior mechanical, durability, and workability properties that far exceed those of conventional concrete. To achieve these properties, a specific mix design with a very dense internal structure, fiber reinforcement, and low water-to-binder ratio (w/b) is commonly used. The goal of this research is to develop a non-proprietary UHPC mix with constituent materials that are readily available in the state of Nebraska for bridge construction applications. In developing this mix, the particle packing model is used, and an experimental study of the impact of various design parameters on the …

Standard Design For Nebraska County Bridges, Chungwook Sim, Jiong Hu, Maher K. Tadros, Alexander Bleyhl, David Gee

Nebraska Department of Transportation: Research Reports

Many county-owned bridges in Nebraska need replacement due to their structural deficiency. Most of the bridges needing replacement are in the 40 to 60 ft range. This span range lacks a standard design that fits Nebraska county practices in terms of speed and simplicity of construction. The current systems being used are (a) Precast 1 by 2 ft planks which can span up to 30 ft, (b) Cast-in-place slab bridges which can span up to 50 ft but require extensive field formwork, concrete placing, and curing, and are best when constructed in three-span units, and (c) Inverted tees which can …

Long-Term Performance Evaluation Of Nudeck In Kearney East Bypass, George Morcous, Marc Maguire

Nebraska Department of Transportation: Research Reports

The Kearney East Bypass bridge is the first project that implements the newly developed precast concrete deck system (known as 2nd generation NUDECK). The new system consists of full-depth full-width precast prestressed concrete deck panels that are 12 ft (3.66 m) long each. The panels have covered shear pockets at 4 ft (1.22 m) spacing on each girder line to host clustered shear connectors that are adjustable in height. Narrow unreinforced transverse joints are used to eliminate the need for deck overlay. Also, deck panels are post-tensioned in the longitudinal direction using a new post-tensioning system that eliminates the need …

Condition Assessment Of Bridge Decks With Asphalt Overlay, Sepehr Pashoutani, Jinying Zhu

Nebraska Department of Transportation: Research Reports

Ground penetrating RADAR (GPR) is a widely used nondestructive testing (NDT) method for bridge deck evaluation. However, the current GPR signal and data processing software and algorithms are not able to provide comprehensive information about bridge deck condition. Although the original objective of this research project was to develop GPR analysis algorithms for condition assessment of bridge decks with asphalt overlay, the scope of work has been expanded to concrete bridge decks with or without overlays.

In this study, the research team developed a complete GPR analysis procedure that includes the following components: 1) obtain zero-time for GPR reflection at …

Precast Concrete Deck-To-Girder Connection Using Uhpc, George Morcous, Mostafa Abo El-Khier

Nebraska Department of Transportation: Research Reports

The implementation of ultra-high-performance concrete (UHPC) in bridge construction has been growing rapidly in the last two decades due to its excellent mechanical properties, workability, and durability. This report presents a new UHPC connection between precast concrete deck panels and bridge girders that eliminates changes to the design and production of girder shear connectors commonly used in conventional cast-in-place concrete deck construction. In conventional construction, girder shear reinforcement or studs are extended into the cast-in-place concrete deck to transfer interface shear and create composite section. In the new connection, girder shear reinforcement or studs are kept underneath the deck panels, …

Performance Evaluation Of Inverted Tee (It) Bridge System, Garrett P. Martindale, Daniel Watson, Antony Mohsen Kamal Masoud Kodsy, Mostafa Abo El-Khier, Richard L. Wood, George Morcous

Nebraska Department of Transportation: Research Reports

The Inverted Tee (IT) girder bridge system was originally developed in 1996 by the University of Nebraska–Lincoln (UNL) researchers and Nebraska Department of Transportation (NDOT) engineers. This bridge system currently accounts for over 110 bridges in Nebraska used for both state highways and local county roads. Extensive longitudinal and transverse deck cracking have been observed and noted in numerous bridge inspection reports. Since the IT girder bridge system is relatively new, limited data and knowledge exist on its structural performance and behavior. This study evaluates the IT girder bridge system by conducting twenty field observations as well as recording accelerometer, …

Detection Of Multiple Flaws In Concrete Bridge Decks Using Ultrasonic Wave Propagation, Ece Erdogmus, Eric Garcia, Michael Schuller, Donald Harvey, Kelsey Stithem, Monica Houck

Nebraska Department of Transportation: Research Reports

No abstract provided.

Evaluation Of Adjustable Continuity Joint Variations For Use In The Restore Barrier, Scott Rosenbaugh, Jennifer D. Schmidt, Ronald K. Faller, James C. Holloway

Nebraska Department of Transportation: Research Reports

During MASH TL-4 full-scale crash testing of the RESTORE barrier, concrete cracking and spalling was observed on the barrier beams that would likely require repairs or replacement. This study sought to evaluate joint design alternatives for use in the RESTORE barrier in order to limit the amount of system damage. Three variations of the Adjustable Continuity Joint (ACJ) were identified as potential modifications: 1) incorporating rubber bearing pads within the ACJ, 2) utilizing normal weight concrete instead of lightweight concrete, and 3) incorporating a steel end cap into the ends of the beam segments.

Four dynamic component tests were conducted …

Condition Factor Calibration For Load And Resistance Factor Rating Of Steel Girder Bridges, Joshua Steelman, Pranav M. Shakya

Nebraska Department of Transportation: Research Reports

Load and Resistance Factor Rating (LRFR) is a reliability-based rating procedure complementary to Load and Resistance Factor Design (LRFD). The intent of LRFR is to provide consistent reliability for all bridges regardless of in-situ condition. The primary difference between design and rating is the uncertain severity and location of deterioration, including the potential future loss of strength for an element already evidencing deterioration. Ostensibly, these uncertainties are addressed by applying an additional strength reduction factor: the condition factor, ϕc. Currently, condition factors are nominally correlated to the condition of the member, which can be Good, Fair, or Poor. However, definitions …

Protocol To Evaluate And Load Rate Existing Bridges, Maria Szerszen, Ali Alhajami

Nebraska Department of Transportation: Research Reports

Load tests can be used to verify component and system performance under a known live load and provide an alternative evaluation methodology to analytically computed the load rating of a bridge. Procedures for nondestructive load testing, which involves field observations and measurements of in- service bridges and field testing often can revel additional capacity since analytical bridge rating tend to be fairly conservative. The goal of presented research was to develop a data-driven rating process to assess and rate bridges. This data-driven rating system reduces the subjective judgment of the bridge inspectors through the use of computer models and field …

Continuous Long-Term Health Monitoring Using Ultrasonic Wave Propagation, Ece Erdogmus

Nebraska Department of Transportation: Research Reports

No abstract provided.

Development Of A Transition Between An Energy-Absorbing Concrete Barrier And A Rigid Concrete Butress, Tyler L. Schmidt, Ronald K. Faller, Jennifer D. Schmidt, John D. Reid, Robert W. Bielenberg, Scott Rosenbaugh

Nebraska Department of Transportation: Research Reports

From 2010 to 2015, MwRSF researchers developed the RESTORE barrier, which is a restorable MASH TL-4 median barrier with a steel and concrete rail supported by elastomer posts and steel skids. The research effort reported herein describes the initial development of a transition from the RESTORE barrier to a rigid TL-4 concrete buttress.

The previously-developed RESTORE barrier LS-DYNA model was validated against three full-scale vehicle crash tests. Several design concepts were generated through a series of brainstorming efforts. The primary transition concept consisted of a pin and loop connection between the RESTORE barrier and rigid concrete buttress, which was designed …

Performance Assessment Of Deteriorated And Retrofitted Steel Hp Piles, Joshua Steelman, Steven Stauffer

Nebraska Department of Transportation: Research Reports

No abstract provided.

Integrated 3d Bridge-Condition Visualization (Bcv) To Facilitate Element-Based Bridge Condition Rating (Ebcr), Zhigang Shen, Wayne Jensen

Nebraska Department of Transportation: Research Reports

Routine inspection and maintenance records are essential for bridges to function well throughout their intended lifespan. Although existing bridge management systems are efficient at data storage, it is difficult to conduct comprehensive data analysis and management due to the lack of data integration mechanism. Engineers have to manually put many pieces of bridge drawings and inspection data together to make maintenance or repair/rehab decisions. Building information modeling (BIM) can be applied in bridge asset management area, including bridge inspection/rating to help to integrate the many data pieces. In this project we developed a 3D bridge inspection data management system, using …

Investigation Of Closure Pour Elimination For Phased Construction Of Steel Girder Bridges, Terri R. Norton, Armando Shane

Nebraska Department of Transportation: Research Reports

No abstract provided.

Evaluation Of The Environmental Impacts Of Bridge Deck Runoff, Shannon L. Bartelt-Hunt, Lauren Swadener, Ekizabeth G. Jones

Nebraska Department of Transportation: Research Reports

Bridges are located in very close proximity to receiving waters, and regulatory agencies often require specific stormwater control measures for bridge deck runoff. While there is some information available on roadway runoff, few studies have focused on bridge deck runoff. Currently, there is no information available regarding the impacts of bridge deck runoff on receiving waters in Nebraska. Due to the cost, maintenance, and design issues associated with implementing structural controls for bridge deck runoff, it is important to develop a better understanding of the relationship between bridge deck runoff and potential impacts to receiving streams. The objectives of this …

Rapid Construction Of Pacific Street Bridge, Kromel E. Hanna, George Morcous, Maher K. Tadros

Nebraska Department of Transportation: Research Reports

No abstract provided.

Design And Evaluation Of An Open Combination Traffic/Bicycle Bridge Railing System, Jason A. Hascall, John R. Rohde, Dean L. Sicking, Karla A. Polivka, Ronald K. Faller, James C. Holloway M.S.C.E., E.I.T.

Nebraska Department of Transportation: Research Reports

No abstract provided.

Steel Bridge System With Delayed Composite Action, Atorod Azizinamini, Aaron Jon Yakel

Nebraska Department of Transportation: Research Reports

No abstract provided.