Engineering Commons^™

Cable-To-Post Attachments For A Non-Proprietary High-Tension Cable Barrier – Phase Ii, Scott K. Rosenbaugh, Robert W. Bielenberg, Brandt M. Humphrey, Ronald K. Faller, John D. Reid, Karla A. Lechtenberg

Mid-America Transportation Center: Final Reports and Technical Briefs

The research objectives reported herein were based on further development of cable-to-post attachment hardware for use in the non-proprietary high-tension cable barrier system. Specifically, this project aimed to develop and evaluate alternative attachment designs for the bolted, tabbed bracket and evaluate the use of a larger diameter, keeper rod for use in the top cable attachment.

From a group of over 25 alternative attachment concepts, two tabbed bracket designs were selected for evaluation through dynamic component testing: 1) the lateral shear plate attachment and 2) the drop-in shear plate attachment. The drop-in shear plate concept did not perform as intended, …

Attachment Of A Combination Bridge Rail To Concrete Parapet Utilizing Epoxy Adhesive Anchors, Robert W. Bielenberg, John D. Reid, Scott K. Rosenbaugh, Austin J. Haase, Ronald K. Faller

Mid-America Transportation Center: Final Reports and Technical Briefs

The Iowa Department of Transportation (IaDOT) was interested in investigating the use of epoxy adhesive anchorages

for the attachment of posts used in the BR27C combination bridge rail system. Alternative anchorage concepts were developed using a modified version of the ACI 318-11 procedures for embedded anchor design. Four design concepts were developed for review by IaDOT, including: (1) a four-bolt square anchorage, (2) a four-bolt spread anchorage, (3) a two- bolt centered anchorage, and (4) a two-bolt offset anchorage. IaDOT representatives selected the four-bolt spread anchorage and the two-bolt offset anchorage as the preferred designs for evaluation. In addition to …

Feasibility Analysis Of Phase Transition Signals Based On E-Bike Rider Behavior, Sheng Dong, Jibiao Zhou, Li Zhao, Keshuang Tang, Renfa Yang

Mid-America Transportation Center: Final Reports and Technical Briefs

This article evaluates the feasibility of two scenarios of phase transition signals, that is, the flashing green together with red–yellow light and the green countdown together with red countdown, at signalized intersections in terms of e-bike rider behavior. An evaluation framework is first proposed. During the phase transition, the stop-go and start-up behavioral parameters are collected at four intersections in Shanghai, China. Sensitivity analysis is then performed to identify the most significant factors that influence the occurrence of traffic conflicts during the phase transition. Based on the above analysis results, case studies were finally done to look into safety performance …