Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

University of Central Florida

Theses/Dissertations

2013

Composites

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Nano-Particles In Multi-Scale Composites And Ballistic Applications, Jason Gibson Jan 2013

Nano-Particles In Multi-Scale Composites And Ballistic Applications, Jason Gibson

Electronic Theses and Dissertations

Carbon nanotubes, graphene and nano sized core shell rubber particles have all been extensively researched for their capability to improve mechanical properties of thermoset resins. However, there has been a lack of research on their evaluation for energy absorption in high velocity impact scenarios, and the fundamental mechanics of their failure mechanisms during highly dynamic stress transfer through the matrix. This fundamental research is essential for laying the foundation for improvement in ballistic performance in composite armor. In hard armor applications, energy absorption is largely accomplished through delamination between plies of the composite laminate. This energy absorption is accomplished through …


Low Strain Rate Studies Of Alumina Epoxy Composites Using Piezospectroscopy, Ashley Jones Jan 2013

Low Strain Rate Studies Of Alumina Epoxy Composites Using Piezospectroscopy, Ashley Jones

Electronic Theses and Dissertations

Particulate composites are widely used in many aerospace and military applications as energetic materials, armor materials or coatings and their behavior under dynamic loads have gained increasing significance. The addition of modifiers such as alumina nanoparticles generally facilitates the improvement of the mechanical strength to density ratio due to high specific area and particle rigidity. This allows for sufficient particlematrix bonding and therefore improved stiffness and load transfer in the composite. Photo-luminescent α-alumina nanoparticles when embedded in an epoxy matrix allow for the added benefit of in situ measurements at low strain rates to provide stress-sensitive information using the particle …