Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Comparison Of Additively Manufactured And Wrought 17-4 Ph Stainless Steels In Ultra Low Cycle Fatigue, Timothy Strasser Dec 2020

Comparison Of Additively Manufactured And Wrought 17-4 Ph Stainless Steels In Ultra Low Cycle Fatigue, Timothy Strasser

Graduate Theses and Dissertations

Additive manufacturing (AM) processes allow for creation of complex geometries that are otherwise impractical to fabricate with traditional subtractive methods. AM technology has potential to improve the optimization of seismic lateral force resisting components which dissipate seismic energy through large plastic strains; however, the ultra low-cycle fatigue performance of AM metals are not yet well understood. Void formation during the AM fabrication process has potential to affect performance. This study compares the performance of heat-treated and non-heat-treated AM and wrought 17-4PH stainless steel in Ultra Low Cycle Fatigue. To understand ULCF performance differences between the AM and wrought specimens, post …


Improvement Of Geometric Quality Inspection And Process Efficiency In Additive Manufacturing, Yu Jin May 2020

Improvement Of Geometric Quality Inspection And Process Efficiency In Additive Manufacturing, Yu Jin

Graduate Theses and Dissertations

Additive manufacturing (AM) has been known for its ability of producing complex geometries in flexible production environments. In recent decades, it has attracted increasing attention and interest of different industrial sectors. However, there are still some technical challenges hindering the wide application of AM. One major barrier is the limited dimensional accuracy of AM produced parts, especially for industrial sectors such as aerospace and biomedical engineering, where high geometric accuracy is required. Nevertheless, traditional quality inspection techniques might not perform well due to the complexity and flexibility of AM fabricated parts. Another issue, which is brought up from the growing …