Engineering Commons^™

Experimental Evaluation And Implementation Of Post-Tensioning In Concrete Bridge Decks, Julio A. Ramirez, Gerardo Aguilar

JTRP Technical Reports

A research program was conducted to evaluate the design recommendations for transverse post-tensioning of bridge decks developed in the FHWA/IN/JTRP/2002-26 (SPR-2409) report. The test specimen consisted of a 40x18 ft cast-in-place concrete deck on precast pretensioned girders. Thirty-two tests were carried out by applying different distributions of transverse post-tensioning force, in combination with a changing number of diaphragms, and two conditions of end-restraint at the supports. The transverse post-tensioning stress ranged from 400 to 1 200 psi and the number of diaphragms was reduced from five to zero.

The main findings support the notion that the presence of diaphragms affects …

Development Of Internally Cured Concrete For Increased Service Life, John Schlitter, Ryan Henkensiefken, Javier Castro, Kambiz Raoufi, Jason Weiss, Tommy Nantung

JTRP Technical Reports

Higher strength, lower water to cement ratio (w/c) concrete has been advocated over the last two decades due to its increased strength and reduced permeability. The lower w/c of these concretes makes them susceptible to autogenous shrinkage. This autogenous shrinkage can be significant and can be a contributing factor to early age cracking. Internal curing was investigated as a potential method to improve the durability of concrete pavements and bridge decks. Prewetted lightweight aggregate was used to supply water to the hydrating cement paste. This additional water can counteract the hindered strength development, suspended hydration, autogenous shrinkage, and early age …

High-Performance Concrete Bridge Decks: A Fast-Track Implementation Study Volume 2: Materials, Mateusz Radlinski, Jan Olek

JTRP Technical Reports

The purpose of this research was to examine the applicability of ternary binder systems containing ordinary portland cement (OPC), class C fly ash (FA) and silica fume (SF) for bridge deck concrete. This was accomplished in two parts, the laboratory part and a field application part.

During the laboratory studies, four ternary mixtures, each containing either 20% or 30% FA and either 5% or 7% SF were subjected to four different curing regimes (air drying, 7 days curing compound application and 3 or 7 days wet burlap curing). In general, all four ternary mixtures exhibited very good water and chloride …

Saw-Cutting Guidelines For Concrete Pavements: Examining The Requirements For Time And Depth Of Saw-Cutting, Kambiz Raoufi, Tony Their, W. Jason Weiss, Jan Olek, Tommy E. Nantung

JTRP Technical Reports

Joints are placed in Portland cement concrete pavements (PCCP) to control random cracking. These joints provide a weakened plane that enables a crack to form in a controlled manner, relieving residual stresses that develop when thermal, hygral, or hydration movements are resisted by sub grade and adjoining pavement. While the concept of creating a weakened plane through saw-cutting is straightforward, determining the time and depth of the saw-cut has proven to be complicated. The goal of this project was to reduce the risk for joint raveling and random cracking. Specifically, this project has focused on: developing a procedure for determining …

High-Performance Concrete Bridge Decks: A Fast-Track Implementation Study, Volume 1: Structural Behavior, Robert J. Frosch, Timothy S. Aldridge

JTRP Technical Reports

Transverse cracking of concrete bridge decks is problematic in numerous states. Cracking has been identified in the negative and positive moment regions of bridges and can appear shortly after opening the structure to live loads. To improve the service life of the bridge deck as well as decrease maintenance costs, changes to current construction practices in Indiana are being considered. A typical bridge deck was instrumented which incorporated the following: increased reinforcement amounts, decreasing reinforcement spacing, and high-performance, low-shrinkage concrete. The low shrinkage concrete was achieved using a ternary concrete mix. The objective of this research was to determine the …

Interaction Between Micro-Cracking, Cracking, And Reduced Durability Of Concrete: Developing Methods For Considering Cumulative Damage In Life-Cycle Modeling, Zhifu Yang, W. Jason Weiss, J. Olek

JTRP Technical Reports

It is becoming increasingly popular to utilize numerical simulation models to predict the long-term performance of concrete pavements and structures. The majority of these models have been developed using laboratory test data that considers concrete in an uncracked state. While uncracked concrete exists as the best case scenario, frequent cracking occurs in real structures that could have a profound impact on life cycle performance. Cracks from several sources may accumulate and interact thereby accelerating the deterioration of concrete. For example, the distributed cracking caused by freeze/thaw damage can substantially increases the rate of water absorption and reduces the load carrying …

Asphalt Additives To Control Rutting And Cracking, Rebecca Mcdaniel, Ayesha Shah

JTRP Technical Reports

This report presents the results of an investigation of the performance of a variety of materials added to asphalt binders and mixtures to change their properties, particularly with respect to rutting and cracking. The approach included a field trial of seven polymer and particulate modifiers, supplemented by laboratory characterization of the materials used in the field. The modifiers evaluated included PAC, Novophalt, Multigrade asphalt cement, polyester fibers, Neoprene, SBR and asphalt rubber. The field trial showed that different modifiers do yield different performance. Modifiers are not essential to ensure that the pavement will not rut. None of the mixtures evaluated …

Fatigue Behavior Of Beam Diaphragm Connections With Intermittent Fillet Welds, Part I, Volume 1, Field Evaluation, Tammy L. Canna, Mark D. Bowman

JTRP Technical Reports

This report is the first of a two-part, three volume final report presenting the findings of the research work that was undertaken to evaluate the behavior of Indiana highway bridges with diaphragm members welded directly to the web of the primary beams and girders. Fatigue cracks have been observed at several bridges that utilize the welded diaphragm connection. The seriousness of the cracking and the corresponding potential risk on the integrity of the bridge superstructure were assessed. Inspection and repair guidelines for bridges with the welded diaphragm connections were also developed as part of the research effort. This volume presents …

Fatigue Behavior Of Beam Diaphragm Connections With Intermittent Fillet Welds, Part I, Volume 2, Laboratory Fatigue Evaluation, Amy S. Barth, Mark D. Bowman

JTRP Technical Reports

This report is the second of a two-part, three volume final report presenting the findings of the research work that was undertaken to evaluate the behavior of Indiana highway bridges with diaphragm members welded directly to the web of the primary beams and girders. Fatigue cracks have been observed at several bridges that utilize the welded diaphragm connection. The seriousness of the cracking and the corresponding potential risk on the integrity of the bridge superstructure were assessed. Inspection and repair guidelines for bridges with the welded diaphragm connections were also developed as part of the research effort. This volume presents …

Mid-Panel Cracking Of Portland Cement Concrete Pavements In Indiana, Hung-Ming Chen, Yunus Dere, Elisa D. Sotelino, Graham C. Archer

JTRP Technical Reports

Portland cement concrete slabs are a common form of highway pavements in Indiana. As a result of their widespread use, the economic impact of their maintenance and life span is therefore tremendous. In Indiana, these types of pavements have been experiencing premature random transverse mid-panel cracking. This phenomenon has been observed under a variety of environmental and traffic conditions. Also, it has been found that the cracking occurs in conjunction with the opening of the lanes to traffic, within months of construction. In this project, a research synthesis was carried out to determine exactly what the current state of knowledge …

Using Pyrolized Carbon Black (Pcb) From Waste Tires In Asphalt Pavement (Part 1, Limestone Aggregate), Taesoon Park, C. W. Lovell

JTRP Technical Reports

This study presents the viability of using PCB as an additive in hot mix asphalt concrete. Different ratios of PCB (5%, 10%, 15%, and 20% by weight of asphalt) were blended with two grades of asphalt (AC-10 and AC-20). The complete behaviors of the PCB modified asphalt concrete were investigated by comprehensive laboratory testing and evaluation. The Marshall method was used to determine the optimum binder content and the mechanical properties and void relationships were investigated by this method. The Gyratory Testing Machine was used to define the stress-strain relationships of the PCB mixtures. The rutting potential of PCB mixtures …