Engineering Commons^™

Petri Net Modeling And Performance Analysis Of Can Fieldbus, Ji-Qiong Zhou

Theses

The CAN FB (Controller Area Network FieldBus) has been in existence for ten years. It supports automated manufacturing and process control environments to interconnect intelligent devices such as valves, sensors, and actuators. CAN FieldBus has a high bit rate and the ability to detect errors. It is immune to noise and resistant to shock, vibration, and heat. Two recently introduced mechanisms, Distributed Priority Queue (DPQ) and Priority Promotion (PP) enable CAN FieldBus networks to share out the system bandwidth and grant ail upper bound on the transmission times so as to meet the requirements in real-time communications. Modeling and analysis …

Computer Aided Manufacturing For Production Environment, Biren K. Parikh

Theses

Investments in new technology like Computer Aided Manufacturing (CAM) increased in the past few years because of the foreign competition in the world market as well as on the home ground. Improper investment in CAM and CIM resulted in the "Islands of Automation" instead of an integrated system. These "Islands of Automation" have created new problems for production planning and factory communication.

The objective of the thesis is to develop the methodology to selection and implementation of the CAM system in the production environment. It is to be noted that a CAM system is part of the overall CIM implementation, …

Shop Floor Planning And Control In Integrated Manufacturing Systems, Tahir Mahmood

Theses

The implementation of a shop floor planning and control system is a prerequisite in establishing an effective computer integrated manufacturing system. A shop floor control system integrates management production goals with the capabilities and limitations of the manufacturing plant. Shop floor planning begins with a long term rough cut capacity plan and evolves into near term, capacity requirements and input/output plans. Shop floor control provides a status of in-process operations and a measure of the plants success in executing the plan. Effective use of technology on shop floor increases the efficiency of the manufacturing plant. Simulation is an important tools …

Clustering Algorithm For Local Area Network Design In A Cim Environment, A. C. Manjunath

Theses

Communication systems have come to be regarded as being one of the most important aspects in manufacturing enterprises in recent years. It continues to offer enormous potential for improving the efficiency of manufacturing enterprises through Computer Integrated Manufacturing (CIM). It is true however that this potential cannot be realized by developments on the communications front alone. Strategic and economic considerations in installing a communications system in a manufacturing environment is of vital significance.

This thesis, at the outset attempts to bring out some of the issues in the area of communications (research), specifically in relation to CIM. A perception of …

Off-Line Programming Using Igrip, Narahari K. Bhandary

Theses

AT&T's FWS-200 (Flexible Work Station) has been modeled and simulated to implement Off-Line Programming (OLP). IGRIP (Interactive Graphics Robot Instruction Program) from Deneb Robotics, Inc. has been used to simulate the FWS operation.

A GSL(Graphics Simulation Language) program has been used to simulate the chip placements during PCB assembly. The program leads the user through the motions of chip placement, and after the simulation run downloads the motion sequence to the FWS. The animation sequences of the FWS have been downloaded to the FWS on the Factory Floor using a C program, which is utilized to communicate the data to …

A Process For Implementing Cim In A Small Manufacturing Facility, Tushar R. Desai

Theses

This work is dedicated to small manufacturing enterprises seeking to explore Computer Integrated Manufacturing (CIM) technology, which is the recent trend in the manufacturing world. The main theme of this thesis is to improve productivity, product quality and reliability, and to reduce costs by integrating various discipline in small manufacturing environment, using computer technology.

To achieve this goal, a hypothetical small manufacturing company was chosen as a subject. The typical functional and organizational structures were analyzed and possible problem areas were highlighted. The problems relating to manufacturing process were studied in detail, and possible solutions were proposed to computerize the …