Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Fabrication Of 2-2 Connectivity Pzt/Thermoplastic Composites For High Frequency Linear Arrays, Wayne Huebner, Mary R. Reidmeyer, L. Busse, Jeffry W. Stevenson
Fabrication Of 2-2 Connectivity Pzt/Thermoplastic Composites For High Frequency Linear Arrays, Wayne Huebner, Mary R. Reidmeyer, L. Busse, Jeffry W. Stevenson
Materials Science and Engineering Faculty Research & Creative Works
An alternate approach for fabricating PZT/polymer composites with 2-2 connectivity with fine scales is described. Thin (less than or equal to 20 micrometers) sintered PZT plates and sheets of a thermoplastic polymer film (less than or equal to 10 micrometers) were bonded together via thermal processing. Stack sintering of tape cast PZT generated the necessary PZT plates, while tape cast polymers were used to control the thermoplastic thickness. Composite blocks were cut to required dimensions for linear arrays, electroded, and poled. Electromechanical properties were measured to evaluate the composites. The significance of this fabrication technique is that it is able …
A Study Of The Sintering Mechanism Of Pzt-Based Piezoceramics, Wayne Huebner, Pei Wen Lu, Wanrong Xue
A Study Of The Sintering Mechanism Of Pzt-Based Piezoceramics, Wayne Huebner, Pei Wen Lu, Wanrong Xue
Materials Science and Engineering Faculty Research & Creative Works
The densification behavior a PZT-based composition with additions of BiFeO3 as a flux was studied. Two different PZT powders were studied with varying initial particle sizes. Results clearly showed that BiFeO3 forms a low temperature liquid that aids in the densification behavior, with 3 mole% being optimum. Fine particle sizes substantially improved the density at low temperatures, with the net result that ceramics could be densified in air without the aid of a lead source. The corresponding electromechanical properties were typical of a hard PZT formulation.