Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Effect Of Wall Thickness And Build Quality On The Compressive Properties Of 304l Thin-Walled Structures Fabricated By Slm, Myranda Spratt, Sudharshan Anandan, Rafid M. Hussein, Joseph William Newkirk, K. Chandrashekhara, Heath Misak, Michael Walker
Effect Of Wall Thickness And Build Quality On The Compressive Properties Of 304l Thin-Walled Structures Fabricated By Slm, Myranda Spratt, Sudharshan Anandan, Rafid M. Hussein, Joseph William Newkirk, K. Chandrashekhara, Heath Misak, Michael Walker
Materials Science and Engineering Faculty Research & Creative Works
The specific strength of lightweight lattice structures built with SLM is of interest to the aerospace industry. Honeycombs were manufactured with increasing wall thicknesses (which increases density) and tested under compression. The optimal strength to density ratio was determined from the resulting data. The build quality was also evaluated to determine how/if the results were influenced by the specimen quality. Differences between the nominal and as-built geometry were identified, but considered to be minimal. Microstructural evaluation of the specimens revealed a possible dependence on the ‘border scan’ properties, as the thickness of the specimens was such that the board scan …
Efficiency Of Solid Inclusion Removal From The Steel Melt By Ceramic Foam Filter: Design And Experimental Validation, Soumava Chakraborty, Ronald J. O'Malley, Laura Bartlett, Mingzhi Xu
Efficiency Of Solid Inclusion Removal From The Steel Melt By Ceramic Foam Filter: Design And Experimental Validation, Soumava Chakraborty, Ronald J. O'Malley, Laura Bartlett, Mingzhi Xu
Materials Science and Engineering Faculty Research & Creative Works
An investigation was performed to measure the efficiency of solid alumina inclusion removal by filtration during casting. A mold design was developed using modeling software to produce two castings that fill simultaneously, one with a filter and the other without a filter. The design avoided vortex formation and thus air entrainment, which helped to avoid reoxidation inside the mold cavity. Samples from these castings were analyzed utilizing an SEM/EDS system with automated feature analysis (AFA) to measure the efficiency of inclusion removal using a 20 ppi zirconia foam filter. This study also documents the occurrence of inclusion flotation and agglomeration …