Engineering Commons^™

An Investigation Of Signs For Median Crossovers, Gillian M. Worsey

Doctoral Dissertations

“This paper describes a study of advance warning signs for median crossovers on divided highways. Candidate crossover signs were identified from a literature review, survey of current State practices and discussions with FHWA personnel. Seven of these signs were selected for further testing in a laboratory study for legibility, understanding and driver preference. Sixty subjects representing a cross-section of drivers took part in the study, thirty at the Turner-Fairbanks Highway Research Center in McLean, Virginia and thirty at the University of Missouri--Rolla in Rolla, Missouri.

Two of the seven signs were word messages and five were symbolic signs. The results …

Structural Design Of Coal-Fueled Power Plant Ductwork, Stanley Pearce Rader

Doctoral Dissertations

"An absence of a comprehensive procedure for design of coal-fueled power plant ductwork currently exists in the publicly available literature. This dissertation presents such a procedure.

An overview of the ductwork design environment, including major components of the air and flue gas flow paths, design loads and temperatures, corrosion considerations, and physical configurations, is given. Design criteria for materials, corrosion inhibition, minimum plate thicknesses, temperature effects, allowable stresses and deflections, and vibrations are proposed. A detailed design procedure based on the allowable stress design philosophy is presented, and computer programs implementing the design procedure are provided. An alternate design procedure …

Oxidation Kinetics Of Polycrystalline Srtio₃ And Lacro₃, Chi-Kung Jerry Yu

Doctoral Dissertations

"The oxidation kinetics of polycrystalline SrTiO₃ and LaCrO₃ were determined by measuring the time and temperature dependence of the weight and conductivity change of reduced samples. A region of fast diffusion followed by a reduced diffusion tail was observed in the TGA measurements. This observation can be interpreted as the initial diffusion along the boundaries and then spreading out into the lattice. The absence of the tail in the conductivity measurements is due to the high electron and hole mobility at the boundaries. The electrical conductivity and TGA results on Nb-doped LaCrO₃ show that at low oxygen …

Web Crippling Of High Strength Cold-Formed Steel Beams, Chiravut Santaputra

Doctoral Dissertations

"The structural behavior of high strength cold-formed steel beams subjected primarily to web crippling was investigated analytically and experimentally. In this study hat sections and I-beams, formed from five different types of high strength sheet steels commonly used in the automobile industry, were investigated under various loading conditions. The yield strengths of these sheet steels vary from 58 to 165 ksi.

In addition to the test data gathered in this phase of study, the experimental results obtained from the beam tests conducted at Inland Steel Company and Ford Motor Company were carefully evaluated. The evaluation indicated that the present available …

The Modeling And Analysis Of Multi-Component, Multivalent Biospecific Adsorption, Bo Henrik Arve

Doctoral Dissertations

"A general model is presented and used to predict the dynamic behavior of the adsorption, wash, and elution stages of biospecific adsorption (affinity chromatography) in finite bath and column operations. The model accounts for film and pore diffusional mass transfer resistances and the rates of interaction between adsorbates and ligands. For column operations the effect of axial dispersion in the flowing fluid stream is included. The model is applicable to single and multi-component biospecific as well as non-specific adsorption, and the adsorbates may be monovalent or multivalent. In the elution stage both non-selective and selective elution of monovalent adsorbates is …