Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Effect Of Convection Associated With Cross-Section Change During Directional Solidification Of Binary Alloys On Dendritic Array Morphology And Macrosegregation, Masoud Ghods
ETD Archive
This dissertation explores the role of different types of convection on macrosegregation and on dendritic array morphology of two aluminum alloys directionally solidified through cylindrical graphite molds having both cross-section decrease and increase. Al- 19 wt. % Cu and Al-7 wt. % Si alloys were directionally solidified at two growth speed of 10 and 29.1 µm s-1 and examined for longitudinal and radial macrosegregation, and for primary dendrite spacing and dendrite trunk diameter.
Directional solidification of these alloys through constant cross-section showed clustering of primary dendrites and parabolic-shaped radial macrosegregation profile, indicative of “steepling convection” in the mushy-zone. The degree …
Forming A Metal Matrix Nanocomposite (Mmnc) With Fully Dispersed And Deagglomerated Multiwalled Carbon Nanotubes (Mwcnts), Mahesh Kumar Pallikonda
Forming A Metal Matrix Nanocomposite (Mmnc) With Fully Dispersed And Deagglomerated Multiwalled Carbon Nanotubes (Mwcnts), Mahesh Kumar Pallikonda
ETD Archive
Carbon Nanotubes (CNTs) with their exceptional properties will facilitate the Metal matrix composites (MMC) to exhibit good mechanical properties, thermal and electrical conductivities, corrosion resistance, etc. The critical factor that holds the development of the Metal matrix Nanocomposites (MMNC) by using CNTs is the tendency of CNTs to form clusters (agglomerations) due to their high Van der Waals attractions. Due to this factor, low density and other properties of the CNTs, there has been a delay in harnessing their ultimate potential.
Existing literature in contemporary times from the works of few researches in Nanocomposites shows the prevalence of using surfactants …