Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

California Polytechnic State University, San Luis Obispo

Series

2011

Drip

Articles 1 - 3 of 3

Full-Text Articles in Engineering

Effects Of Sprinkler, Partial Sprinkler/Drip, And Drip Only Irrigation On Strawberry Transplants 2010-2011, Stuart Styles Aug 2011

Effects Of Sprinkler, Partial Sprinkler/Drip, And Drip Only Irrigation On Strawberry Transplants 2010-2011, Stuart Styles

BioResource and Agricultural Engineering

The purpose of the project is to develop an analysis of the current irrigation practices of the strawberry growers on the Central Coast of California. The primary research evaluation is during the establishment of transplants where sprinklers are typically used even though drip irrigation is available. Growers have been selected from Oxnard, Santa Maria, and Watsonville to provide a good cross section of the different strawberry growing areas.

The specific objectives of the project are to: (1) set up a research areas and control plots on a demonstration scale, (2) determine the key factors that affect the problems in early …


Low Pressure Drip/Micro System Design – Analysis Of Potential Rebate, Charles M. Burt, Daniel J. Howes Jan 2011

Low Pressure Drip/Micro System Design – Analysis Of Potential Rebate, Charles M. Burt, Daniel J. Howes

BioResource and Agricultural Engineering

Drip/micro irrigation systems are often referred to as “low pressure” systems because the required emitter pressures are relatively low (6-12 psi). However, the pump discharge pressures of systems on flat ground throughout California average 40 psi. This report examines readily attainable system losses by examining individual components of the drip/micro system.


Irrigation District Flow Metering, Charles M. Burt Jan 2011

Irrigation District Flow Metering, Charles M. Burt

BioResource and Agricultural Engineering

Most readers of this publication are probably somewhat familiar with USBR Reclamation Reform Act requirements for measurement of water deliveries to farm turnouts, in cases where the water is supplied by Reclamation facilities. Basically, volumes within the Mid-Pacific Region are supposed to be measured within ±6%. This sounds like a fairly straightforward requirement, but the reality is anything but simple.