Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Design And Implementation Of Eight-Legged Robotic Transporter, Jeremy David Depangher
Design And Implementation Of Eight-Legged Robotic Transporter, Jeremy David Depangher
Master's Theses
This thesis contains the design, manufacturing, and testing of a functional eight-legged robotic transporter based on the concept design laid out in U.S. Patent 7,246,671. The device is intended to achieve three different sequences of motion: regular driving, obstacle climbing, and stair climbing. The prototype was carried through concept design, analysis, selection of materials and components, manufacturing, software development, and final assembly and testing. The device can be assembled under multiple configurations, which harbor certain advantages and disadvantages. The results of the testing encourage the continuation of a second iteration of this concept.
Robotic Fingerspelling Hand For The Deaf-Blind, Jerry Vin
Robotic Fingerspelling Hand For The Deaf-Blind, Jerry Vin
Master's Theses
Because communication has always been difficult for people who are deaf-blind, The Smith-Kettlewell Eye Research Institute (SKERI), in conjunction with the California Polytechnic State University Mechanical Engineering department, has commissioned the design, construction, testing, and programming of a robotic hand capable of performing basic fingerspelling to help bridge the communication gap. The hand parts were modeled using SolidWorks and fabricated using an Objet rapid prototyper. Its fingers are actuated by 11 Maxon motors, and its wrist is actuated by 2 Hitec servo motors. The motors are controlled by Texas Instruments L293D motor driver chips, ATtiny2313 slave microcontroller chips programmed to …
Material Characterization Of Nitinol Wires For The Design Of Actuation Systems, Sean P. Kennedy
Material Characterization Of Nitinol Wires For The Design Of Actuation Systems, Sean P. Kennedy
Master's Theses
A series of tests were performed on nickel-titanium alloy wire, also known as nitinol, to determine the plausibility of designing an actuator using this wire as the method of actuation. These tests have been designed to fully characterize how the wire behaves under steady state and transient conditions allowing for a specific wire selection to be made given known actuator specifications which will result in an efficient design. The wire transient data can be used to design a controller which reduces the actuation time. The research done for the overall project covers a wide scope including wire hysteresis, nitinol transition …
Design, Fabrication, And Testing Of An Emr Based Orbital Debris Impact Testing Platform, Jeffrey J. Maniglia Jr.
Design, Fabrication, And Testing Of An Emr Based Orbital Debris Impact Testing Platform, Jeffrey J. Maniglia Jr.
Master's Theses
This paper describes the changes made from Cal Poly’s initial railgun system, the Mk. 1 railgun, to the Mk. 1.1 system, as well as the design, fabrication, and testing of a newer and larger Mk. 2 railgun system. The Mk. 1.1 system is developed as a more efficient alteration of the original Mk. 1 system, but is found to be defective due to hardware deficiencies and failure, as well as unforeseen efficiency losses. A Mk. 2 system is developed and built around donated hardware from the Naval Postgraduate School. The Mk. 2 system strove to implement an efficient, augmented, electromagnetic …