Engineering Commons^™

A Numerical Study Of The Lateral Hyporheic Flow About A Channels Confluence, C. Gualtieri

International Congress on Environmental Modelling and Software

Stream and pore waters continuously interact and mix within streambeds due to spatial and temporal variations in channel characteristics. This mixing is termed as hyporheic exchange and the zone where groundwater and stream water are mixing is called hyporheic zone, which can greatly affect water quality is both surface and subsurface water systems. Typical examples of hyporheic fluxes are those under bedforms, intra-meander or across point bar deposits, while the lateral and vertical hyporheic exchanges about a riverine confluence was almost never investigated.

The paper presents some results of a numerical study carried out to investigate the basic features of …

Comparison Of Airfoil Precomputational Analysis Methods For Optimization Of Wind Turbine Blades, Ryan Barrett, Andrew Ning

Faculty Publications

The objective of this research was to develop and compare various airfoil precomputational parameterization and analysis techniques for aerostructural optimization of wind turbine blades. The airfoils along the blade were added as optimization design variables through pre-computational parameterization methods using thickness-to-chord ratios and blended airfoil family factors. The airfoils' aerodynamic performance was analyzed with three methods of increasing fidelity: a panel method (XFOIL), Navier-Stokes based computational fluid dynamics (RANS CFD), and wind tunnel data. The optimizations minimized mass over annual energy production (m/AEP) and thereby approximated the minimization of cost of energy. The results were compared to the NREL 5-MW …

Implementations Of Fourier Methods In Cfd To Analyze Distortion Transfer And Generation Through A Transonic Fan, Marshall Warren Peterson

Theses and Dissertations

Inlet flow distortion is a non-uniform total pressure, total temperature, or swirl (flow angularity) condition at an aircraft engine inlet. Inlet distortion is a critical consideration in modern fan and compressor design. This is especially true as the industry continues to increase the efficiency and operating range of air breathing gas turbine engines. The focus of this paper is to evaluate the Computational Fluid Dynamics (CFD) Harmonic Balance (HB) solver in STAR-CCM+ as a reduced order method for capturing inlet distortion as well as the associated distortion transfer and generation. New methods for quantitatively describing and analyzing distortion transfer and …