Engineering Commons^™

Comparison Of Scaling Performance Between Sidewalks Placed Using Hot And Cold Weather Concreting Procedures, Likhitha Rudraraju

Masters Theses

This study investigates the performance of concrete sidewalks placed using hot and cold weather concreting practices. The effect that curing methods, types of deicers, and supplementary cementitious material content have on the scaling resistance of concrete is examined in the laboratory and the field. After one winter, petrographic analysis was conducted on the cores from the sidewalk panels.

The results from field evaluation indicate that the concrete sidewalks placed using hot weather concreting showed better resistance against scaling than those placed using cold weather concreting. The results also suggest that the effect of curing method depends on the concreting procedure …

Influence Of Pumping Parameters On The Freeze-Thaw And Scaling Resistance Of Highly Workable Concrete, Alexandra Nicole Wehar

Masters Theses

“Over the past 60 years, pumping concrete has gained popularity due to the economic and technical benefits that typically accompanies it. However, boom configuration and flow rate can adversely affect freeze-thaw and scaling resistance of concrete due to the effects of pressure on the air-void system. Therefore, the objective of this research is to assess the influence of different pumping parameters on the durability of hardened self-consolidating concrete. Self-consolidating, flowable, and conventional concrete mixtures were tested during large scale pumping experiments positioning the pump boom in an “A” and a flat shape as well as using different pumping speeds. In …

Development Of A Support Structure For Multi-Rotor Wind Turbines, Gaurav Murlidhar Mate

Masters Theses

The earliest design of a wind power system with multiple rotors on a single support structure dates back to the late 1800s. Such a system called a Multi-Rotor Wind Turbine (MRWT) was proposed by several researchers due to its perceived advantages over a single-rotor wind turbine. As turbine size increases, power produced by a rotor tends to scale up as the square of its diameter, as opposed to rotor weight which varies as its cube. So, several smaller rotors will weigh and cost less than one large rotor producing the same power. MRWTs offer several advantages such as better distribution …

Evaluation Of Geometric Scale Effects For Scramjet Isolators, Jaime Enrique Perez

Masters Theses

A numerical analysis was conducted to study the effects of geometrically scaling scramjet inlet-combustor isolators. Three-dimensional fully viscous numerical simulation of the flow inside constant area rectangular ducts, with a downstream back pressure condition, was analyzed using the SolidWorks Flow Simulation software. The baseline, or 1X, isolator configuration has a 1” x 2.67” cross section and 20” length. This baseline configuration was scaled up based on the 1X configuration mass flow to 10X and 100X configurations, with ten and one hundred times the mass flow rate, respectively. The isolator aspect ratio of 2.67 was held constant for all configurations. To …