Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Investigation Of Engineering Properties Of Normal And High Strength Fly Ash Based Geopolymer And Alkali-Activated Slag Concrete Compared To Ordinary Portland Cement Concrete, Nabeel Farhan, M Neaz Sheikh, Muhammad N. S Hadi
Investigation Of Engineering Properties Of Normal And High Strength Fly Ash Based Geopolymer And Alkali-Activated Slag Concrete Compared To Ordinary Portland Cement Concrete, Nabeel Farhan, M Neaz Sheikh, Muhammad N. S Hadi
Faculty of Engineering and Information Sciences - Papers: Part B
Fly ash-based geopolymer (FAGP) and alkali-activated slag (AAS) concrete are produced by mixing alkaline solutions with aluminosilicate materials. As the FAGP and AAS concrete are free of Portland cement, they have a low carbon footprint and consume low energy during the production process. This paper compares the engineering properties of normal strength and high strength FAGP and AAS concrete with OPC concrete. The engineering properties considered in this study included workability, dry density, ultrasonic pulse velocity (UPV), compressive strength, indirect tensile strength, flexural strength, direct tensile strength, and stress-strain behaviour in compression and direct tension. Microstructural observations using scanning electronic …
Selective Atomic-Level Etching On Short S-Glass Fibres To Control Interfacial Properties For Restorative Dental Composites, Kiho Cho, Guannan Wang, Raju Raju, Jian Fang, Ginu Rajan, Martina Stenzel, Paul Farrar, Gangadhara B. Prusty
Selective Atomic-Level Etching On Short S-Glass Fibres To Control Interfacial Properties For Restorative Dental Composites, Kiho Cho, Guannan Wang, Raju Raju, Jian Fang, Ginu Rajan, Martina Stenzel, Paul Farrar, Gangadhara B. Prusty
Faculty of Engineering and Information Sciences - Papers: Part B
Interfacial bonding between fibre and matrix is most critical to obtain enhanced mechanical properties of the resulting composites. Here we present a new surface tailoring method of selective wet etching and organosilicon monomers (3-(Trimethoxysilyl) propyl methacrylate, TMSPMA) deposition process on the short S-Glass fibre as a reinforcing material, resulting in increased mechanical retention and strong chemical bonding between glass fibres and polymer resin (a mixture of triethylene glycol dimethacrylate (TEGDMA) and urethane dimethacrylate (UDMA) monomers). The effect of surface modification on fibre matrix interfacial strength was investigated through microdroplet tests. An S-Glass fibre treated with piranha solution (a mixture of …