Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Transportation Engineering

2021

Transportation

University of Nebraska - Lincoln

Articles 1 - 6 of 6

Full-Text Articles in Engineering

Research On High-Rap Mixtures With Rejuvenator - Field Implementation, Nitish R. Bastola, Mahdieh Khedmati, Hamzeh Haghshenas Dec 2021

Research On High-Rap Mixtures With Rejuvenator - Field Implementation, Nitish R. Bastola, Mahdieh Khedmati, Hamzeh Haghshenas

Nebraska Department of Transportation: Research Reports

The use of Rejuvenating Agents (RAs), as Recycled Asphalt Pavement (RAP) modifiers, has been increasing over the past years. However, the field performance of asphalt mixtures containing high-RAP materials and modified with RAs has raised some concerns regarding the long-term performance of RAs. This study evaluated the laboratory and field performance of high-RAP mixtures with and without bio-oil RA. Three sets of plant-produced specimens were collected: 1) laboratory-compacted; 2) field-compacted and cored after paving; and 3) field-compacted and cored after one and two years. The Hamburg Wheel Tracking (HWT) test was used to evaluate the specimens' resistance to rutting and …


Design And Detailing Of Cast-In-Place And Precast Concrete Approach Slabs, George Morcous, Mostafa Abo-Elkhier May 2021

Design And Detailing Of Cast-In-Place And Precast Concrete Approach Slabs, George Morcous, Mostafa Abo-Elkhier

Nebraska Department of Transportation: Research Reports

Approach slab is a structural concrete slab that spans from the backwall of the abutment (i.e. end of the bridge floor) to the beginning of the paving section. The purpose of the approach slab is to carry the traffic loads over the backfill behind the abutments to avoid differential settlement that causes bumps at the bridge ends. Cast- in-place concrete approach slab is the current practice in US with various spans, reinforcement, thicknesses, joints, and concrete covers. NDOT has observed premature cracking in a significant number of approach slabs, which could result in a shorter service life and costly repairs/replacements …


Research And Education For Optimizing The Development And Implementation Of An Unmanned Aircraft Program At The Nebraska Department Of Transportation, Wayne Woldt, Jon Starr, Christopher M. U. Neale May 2021

Research And Education For Optimizing The Development And Implementation Of An Unmanned Aircraft Program At The Nebraska Department Of Transportation, Wayne Woldt, Jon Starr, Christopher M. U. Neale

Nebraska Department of Transportation: Research Reports

This report describes the development and implementation of an Unmanned Aircraft System Program at the Nebraska Department of Transportation (NDOT). The project involved the selection and purchase of appropriate UAS and imaging systems for NDOT, education and training for NDOT personnel with classroom and hands-on operation of UAS with the goal of obtaining proficiency and pilot licenses. In addition, the development of policy for the use of UAS within NDOT was accomplished as well as standard operating procedures (SOP) documentation and the development of example case studies of interest to NDOT using the purchased systems and technology.


Evaluating Asct Operations For Dodge Street Corridor, Anuj Sharma, Subhadipto Poddar, Atousa Zarindast, Christopher Day May 2021

Evaluating Asct Operations For Dodge Street Corridor, Anuj Sharma, Subhadipto Poddar, Atousa Zarindast, Christopher Day

Nebraska Department of Transportation: Research Reports

As Adaptive Traffic Control (ATC) is increasingly being implemented by various traffic agencies, careful evaluation is needed of the degree to which a given ATC implementation improves traffic signal performance. The present study details the evaluation of ATC for two arterial corridors in the City of Omaha, Nebraska. Several performance measures were used across two stages of ATC implementation as well as during the unanticipated COVID-19 lockdown stage.

The average travel time and variability in travel time showed that Stage 1 of ATC implementation in Omaha did not improve traffic signal performance for the study’s main corridor, Dodge Street. This …


Feasibility Study: Alternatives To Prevent Settlements And Bumps At Bridge Approach, Seunghee Kim, Jongwan Eun, Yusuf Alhowaidi, Daniel Robertson May 2021

Feasibility Study: Alternatives To Prevent Settlements And Bumps At Bridge Approach, Seunghee Kim, Jongwan Eun, Yusuf Alhowaidi, Daniel Robertson

Nebraska Department of Transportation: Research Reports

This project aims to examine the feasibility of improving the current design practice of the approach slab foundation in Nebraska and the alternative of using geosynthetic reinforcement of soils to prevent the bump issues near the end of bridge approaches via an in-depth numerical simulation study. A large-scale pullout test is also conducted as complementary to provide input parameters for the interaction between the regional soil and selected geosynthetics. Based on the results, it is recommended that the number of grade beam piles could be reduced to 40-50 % of the total number of abutment piles while maintaining the same …


Low-Cost Modal Identification Sensors For Bridge Field Testing, Daniel Linzell, Saaed Eftekhar Azam, Samira Ardani, Ahmed E Rageh Mar 2021

Low-Cost Modal Identification Sensors For Bridge Field Testing, Daniel Linzell, Saaed Eftekhar Azam, Samira Ardani, Ahmed E Rageh

Nebraska Department of Transportation: Research Reports

This report provides a framework for experimental load rating of bridges via inclusion of low-cost dynamic sensors and dynamic tests. Currently 25% of the bridges in Nebraska are posted for live load. According to the National Bridge Inventory (NBI) in 2012, 93% of all postings in the US were based analytical load ratings, 7% were posted using field evaluation and engineering judgement, and 1% were posted using experimental load rating methods.

Instrumentation costs and traffic interruptions can be problematic when load testing is necessary to accurately assess in-situ bridge live load capacity. Recent advances in (i) sensing technology and (ii) …