Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Engineering

Analysis Of Traffic Crash Data In Kentucky (2013-2017), Eric R. Green, Kenneth R. Agent, Jerry G. Pigman, Paul A. Ross Sep 2018

Analysis Of Traffic Crash Data In Kentucky (2013-2017), Eric R. Green, Kenneth R. Agent, Jerry G. Pigman, Paul A. Ross

Kentucky Transportation Center Research Report

Executive Summary

This report documents an analysis of traffic crash data in Kentucky for the years of 2013-2017. A primary objective of this study was to determine average crash statistics for Kentucky highways. Rates were calculated for various types of highways and for counties and cities. Difference criteria were used for exposure.

Average and critical numbers and rates of crashes were calculated for various types of highways in rural and urban areas. These rates used crashes identified on highways where traffic volumes were available. Improved methods of identifying crash locations have resulted in higher rates for the last couple of …


Improvement Of Fatal Crash Analysis And Follow-Up, William Nicholas Staats, Jerry G. Pigman, Kenneth R. Agent, Paul A. Ross Sep 2018

Improvement Of Fatal Crash Analysis And Follow-Up, William Nicholas Staats, Jerry G. Pigman, Kenneth R. Agent, Paul A. Ross

Kentucky Transportation Center Research Report

Executive Summary

Fatalities resulting from traffic crashes in Kentucky increased from a low of 638 in 2013 to 834 in 2016 (a 31% increase), and there is not a full understanding of the underlying causes for this trend. This study analyzes fatal crashes using data from both Kentucky’s crash reports and the National Highway Traffic Safety Administration’s (NHTSA) Fatal Accident Reporting System (FARS) to identify countermeasures to combat increasing fatal crash rates. In addition, this study compares Kentucky’s crash reports to the fatal crash data in FARS to identify data inconsistencies and recommend procedures to eliminate these inconsistencies.

Emphasis was …


Phase Ii Evaluation Of Floor Pan Tearing For Cable Barrier Systems, Dylan T. Meyer, Mojdeh Asadollahi Pajouh, Karla A. Lechtenberg, Ronald K. Faller, Robert W. Bielenberg, James C. Holloway Mar 2018

Phase Ii Evaluation Of Floor Pan Tearing For Cable Barrier Systems, Dylan T. Meyer, Mojdeh Asadollahi Pajouh, Karla A. Lechtenberg, Ronald K. Faller, Robert W. Bielenberg, James C. Holloway

Nebraska Department of Transportation: Research Reports

The objective of this research effort was to mitigate the potential for floor pan tearing and penetration into the occupant compartment by modifying the posts utilized in a prototype cable barrier system. A series of dynamic component tests were conducted on the modified Midwest Weak Post (MWP). A bogie vehicle was equipped with a simulated floor pan designed to replicate the height, thickness, and strength of the floor pan of a Kia Rio. Two methods of post modification were investigated, including edge protection on the top of the MWP as well as weakening of the MWP at the ground line. …


Mash Test No. 3-10 Of A Non-Proprietary, High-Tension, Cable Median Barrier For Use In 6h:1v V-Ditch (Test No. Mwp-9), Mojdeh Asadollahi Pajouh, Karla A. Lechtenberg, Ronald K. Faller, James C. Holloway, Robert W. Bielenberg, Scott K. Rosenbaugh Mar 2018

Mash Test No. 3-10 Of A Non-Proprietary, High-Tension, Cable Median Barrier For Use In 6h:1v V-Ditch (Test No. Mwp-9), Mojdeh Asadollahi Pajouh, Karla A. Lechtenberg, Ronald K. Faller, James C. Holloway, Robert W. Bielenberg, Scott K. Rosenbaugh

Nebraska Department of Transportation: Research Reports

The Midwest Pooled Fund Program has been developing a prototype design for a non-proprietary, high-tension, cable median barrier for use in a 6H:1V median V-ditch. This system incorporates four evenly spaced cables, Midwest Weak Posts (MWPs) spaced at 8 to 16 ft (2.4 to 4.9 m) intervals, and a bolted, tabbed bracket to attach the cables to each post. Full-scale crash testing was needed to evaluate the barrier’s safety performance. According to the Manual for Assessing Safety Hardware 2016 (MASH) testing matrix for cable barriers installed within a 6H:1V median V-ditch, a series of eight full-scale crash tests are required …


Kentucky Traffic Collision Facts 2017, Eric R. Green, Paul A. Ross, Christopher L. Blackden, Kentucky State Police Jan 2018

Kentucky Traffic Collision Facts 2017, Eric R. Green, Paul A. Ross, Christopher L. Blackden, Kentucky State Police

Kentucky Transportation Center Research Report

KENTUCKY’S TRAFFIC COLLISION FACTS report is based on collision reports submitted to the Kentucky State Police Records Branch. As required by Kentucky Revised Statutes 189.635, “every law enforcement agency whose officers investigate a vehicle accident of which a report must be made...shall file a report of the accident...within ten days after investigation of the accident upon forms supplied by the bureau.” The stated purpose of this requirement is to utilize data on traffic collisions for such purposes as will improve the traffic safety program in the Commonwealth. Data contained in this report are based solely on the observations and judgements …