Open Access. Powered by Scholars. Published by Universities.®
- Publication
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Simulation Of Traffic Loading On Highway Bridges, Bernard Enright
Simulation Of Traffic Loading On Highway Bridges, Bernard Enright
Other resources
This work is based on weigh-in-motion measurements for approximately three million trucks obtained from sites in five European countries. Techniques have been developed, supported by photographic evidence, for filtering the measurements to identify and remove unreliable values, and for the classification of extremely heavy vehicles. The collected measurements have been used as the basis for building and calibrating a Monte Carlo simulation model for bridge loading. Two-lane traffic is simulated – either two lanes in the same direction or one lane in each direction. The model allows for vehicles that are both heavier and have more axles than in the …
A New Congested Traffic Load Model For Highway Bridges, Colin C. Caprani, Colm Carey, Bernard Enright
A New Congested Traffic Load Model For Highway Bridges, Colin C. Caprani, Colm Carey, Bernard Enright
Conference papers
Long span highway bridges are critical components of any nation’s infrastructure. Therefore accurate assessment of highway bridge loading is essential, and it is well known that congested traffic governs load effect for such bridges. Current congestion models use conservative assumptions about traffic and inter-vehicle gaps. This research investigates congested traffic flow through the use of traffic microsimulation which has the ability to reproduce complex traffic phenomena based on driver interactions. A time series model has been developed to produce a speed time-series similar to the results of the microsimulation. The speed time-series from the new model, combined with the established …
Importance Of The Tail In Truck Weight Modeling For Bridge Assessment, Eugene J. Obrien, Bernard Enright, Abraham Getachew
Importance Of The Tail In Truck Weight Modeling For Bridge Assessment, Eugene J. Obrien, Bernard Enright, Abraham Getachew
Articles
To predict characteristic extreme traffic load effects, simulations are sometimes performed of bridge loading events. To generalize the truck weight data, statistical distributions are fitted to histograms of weight measurements. This paper is based on extensive WIM measurements from two European sites and shows the sensitivity of the characteristic traffic load effects to the fitting process. A semi-parametric fitting procedure is proposed: direct use of the measured histogram where there are sufficient data for this to be reliable and parametric fitting to a statistical distribution in the tail region where there are less data. Calculated characteristic load effects are shown …