Engineering Commons^™

Columbus, Nebraska: Southern Housing Development Design Proposal, Ryan Weyers, Caiden Dynek, Alex Papa, Brexton Robertson, Kaden Perala

Honors Theses

The following paper proposes the design and creation of a new housing development in the city of Columbus, Nebraska in a lot to the south of the city and directly north of the Columbus wastewater treatment plant. The goal of this proposal is to provide readers with confidence that our company is the most qualified to complete the project and will create the safest, most comfortable, most efficient, and most cost-effective final design. This proposal seeks to offer a solution to the lack of affordable housing for the growing workforce in Columbus. In order to arrive at this solution, each …

Evaluation Of The Geotechnical And Foundation Components On Jud Site, Mirabel W. Nkanor

Honors Theses

This thesis is part of the senior design final project of the Civil Engineering Department at the University of Mississippi. Geotechnical and foundation analyses were done on a proposed construction project for a multi-family home in Orlando, Florida. This evaluation done in this thesis follows the pre-existing geotechnical report on the side, USDA soil reports, ASCE Code 32-01 (Design of Foundations), and ASCE-7 Section 12.31.1 (Foundations and Superstructure-to-Foundation Connections).

A structural system was selected from the proposed location, on the corner of South Conway and Judge Road, and an evaluation of the Bearing Load capacity was completed to determine the …

An Investigation Into Aluminum’S Torsional Behavior Of Circular, Rectangular, And Square Cross-Sections, Marly Mcclintock

Honors Theses

The Specifications for Aluminum Structures (2020) provides the standards that structural engineers follow for aluminum design. Included in these specifications are limit state equations that use strength properties to calculate a member’s initial yield, full yield, and rupture values. One limit state that the standards currently neglect is the torsional failure of solid bars. Torsion is the act of rotation caused by a twisting force, otherwise known as torque. Future installments of the specifications hope to include torsional yielding and rupture equations, so this study investigates the validity of these proposed equations.

Two different aluminum alloys were investigated for this …