Engineering Commons^™

Evaluation Of The Geotechnical And Foundation Components On Jud Site, Mirabel W. Nkanor

Honors Theses

This thesis is part of the senior design final project of the Civil Engineering Department at the University of Mississippi. Geotechnical and foundation analyses were done on a proposed construction project for a multi-family home in Orlando, Florida. This evaluation done in this thesis follows the pre-existing geotechnical report on the side, USDA soil reports, ASCE Code 32-01 (Design of Foundations), and ASCE-7 Section 12.31.1 (Foundations and Superstructure-to-Foundation Connections).

A structural system was selected from the proposed location, on the corner of South Conway and Judge Road, and an evaluation of the Bearing Load capacity was completed to determine the …

Evaluating The Effects Of Seismic Loading On Concrete Reinforced Versus Precast Concrete Slab Floor Systems, Mahima Maharjan

Honors Theses

This thesis is part of the senior design capstone project of Ole Miss Department of Civil Engineering. The seismic loadings for the commercial buildings project located in Oxford, Mississippi are evaluated to fulfill the honor thesis requirement. This thesis follows the codes from American Concrete Institute (ACI), International Building Code (IBC), and ASCE-7/SEI (Minimum Design Loads and Associated Criteria for Buildings and Other Structures/Structural Engineering Institute) to design the gravitational loadings and seismic loadings.

Furthermore, a reinforced concrete slab flooring system is replaced with a precast slab flooring system to analyze the most seismic performance effective floor system for the …

Design Of Load Bearing Wall For Low Rise Building With Partially Grouted Reinforced Masonry, Anil Bhatt

Honors Theses

The seismic and wind load acting on the 2-storeyed building of dimension 120 ft x 98 ft located in Oxford, MS, were calculated and the seismic load was considered for the design of the 120 ft long and 24 ft high load-bearing wall because it being critical. The maximum loading was computed using different load combinations. The masonry behavior and masonry specifications were considered to select the masonry unit, grout, and mortar for the load-bearing wall. The seismic design requirement for the shear and slender wall was fulfilled for the special reinforced masonry wall. The in-plane and out-of-plane loading scenarios …