Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Turbulent Effects On Building Pressure Using A Two-Dimensional Finite Element Program, Jonese Woods
Turbulent Effects On Building Pressure Using A Two-Dimensional Finite Element Program, Jonese Woods
Civil Engineering Undergraduate Honors Theses
Much of the knowledge about building aerodynamics today was obtained from physical testing like wind tunnel testing. Physical testing is time-consuming and very expensive. As a result, computational methods like the finite element method are being explored for use in building aerodynamics. Despite several years of research, there is still not a clear understanding of the peak pressure on buildings due to turbulence. Many of the research thus far has focused on comparing different computational methods. However, much work is needed in understanding the capability of the individual methods. In this work, a two-dimensional finite element program is used to …
Tension Splitting Strength Of Bcsa Concrete Cylinders, Andrew Steven Deschenes
Tension Splitting Strength Of Bcsa Concrete Cylinders, Andrew Steven Deschenes
Civil Engineering Undergraduate Honors Theses
The focus of this research was to compare the tension splitting strength (TSS) of belitic calcium sufloaluminate (BCSA) cement concrete to tensile strength predicted by the American Concrete Institute (ACI) and to similarly proportioned portland cement (PC) concrete. BCSA is a rapid-setting cement with higher early strength, higher ettringite content, and lower calcium silicate hydrate (C-S-H) content than PC. PC and BCSA cement concrete cylinders were broken at different ages in both uniaxial compression and TSS. It was found that BCSA had a similar TSS to both the ACI prediction and PC TSS, but the results require further testing for …
Young’S Modulus As A Measurement To Estimate Damage Related With Alkali-Silica Reaction In Concrete., Anazaria J. Ortega Gonzalez
Young’S Modulus As A Measurement To Estimate Damage Related With Alkali-Silica Reaction In Concrete., Anazaria J. Ortega Gonzalez
Civil Engineering Undergraduate Honors Theses
The main purpose of this research is to compare two nondestructive methods to assess Alkali-Silica reaction (ASR) in concrete. Fifteen concrete prisms were cast using aggregates with different Alkali-Silica reactivity such as Jobe sand and Van Buren sand. The change in strain, shear wave velocity and Young’s modulus were determined according to ASTM C129 and ASTM C215, respectively. This data was collected by Dillon K Self, who determined that the shear wave velocity and strain are inversely proportional. However, when single cracking in the concrete specimen transition to map cracking, the shear wave velocity dropped significantly, whereas the strain value …