Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Development Of A Dc-Lsnd Welding Process For Gmaw On Dh-36 Steel, Raymond Holder, Nathan Larkin, Huijun Li, Lenka Kuzmikova, Zengxi Pan, John Norrish
Development Of A Dc-Lsnd Welding Process For Gmaw On Dh-36 Steel, Raymond Holder, Nathan Larkin, Huijun Li, Lenka Kuzmikova, Zengxi Pan, John Norrish
Nathan Larkin
Weld induced distortion correction is a major cost within the shipbuilding industry. This paper investigates the use of an active cooling process known as Dynamically Controlled - Low Stress No Distortion (DC-LSND) Welding on DH-36 steel. Thermal profiles are obtained and distortion measurements are also achieved. Results show that the application of a localised cryogenic cooling source trailing the welding arc can significantly reduce weld induced distortion using the GMAW process. The effect of forced cooling on the weld microstructure is also observed.
Investigation Into Feasibility Of Hybrid Laser-Gmaw Process For Welding High Strength Quenched And Tempered Steel, Lenka Kuzmikova, Nathan Larkin, Zengxi Pan, Mark Callaghan, Huijun Li, John Norrish
Investigation Into Feasibility Of Hybrid Laser-Gmaw Process For Welding High Strength Quenched And Tempered Steel, Lenka Kuzmikova, Nathan Larkin, Zengxi Pan, Mark Callaghan, Huijun Li, John Norrish
Nathan Larkin
In this study, the feasibility of hybrid laser-gas metal arc welding process for replacement of conventional flux-cored arc welding procedure for welding high strength quenched and tempered steel was investigated. Experimental work focused on optimisation of process parameters to produce joint with desired properties. Hardness of the weld heat affected zone produced by both processes has been measured. Productivity and cost effectiveness of both processes were compared. It was concluded that hybrid laser-gas metal arc welding process is suitable for welding high strength quenched and tempered steel.