Open Access. Powered by Scholars. Published by Universities.®
- Publication
Articles 1 - 3 of 3
Full-Text Articles in Engineering
Voltage Security Constrained Reactive Power Optimization Incorporating Wind Generation, L G. Meegahapola, E Vittal, A Keane, D Flynn
Voltage Security Constrained Reactive Power Optimization Incorporating Wind Generation, L G. Meegahapola, E Vittal, A Keane, D Flynn
Dr Lasantha G Meegahapola
This paper presents a comparative analysis between conventional optimal power flow (OPF) and voltage constrained OPF strategies with wind generation. The study has been performed using the New England 39 bus system with 12 doublyfed induction generator (DFIG) based wind farms installed across the network. A voltage security assessment is carried out to determine the critical wind farms for voltage stability enhancement. The power losses and individual wind farm reactive power generation have been compared with and without voltage stability constraints imposed on the OPF simulation. It is shown that voltage constrained OPF leads to much greater active power losses …
Optimization Of Frt Active Power Performance Of A Dfig During Transient Grid Faults, L Meegahapola, Damian Flynn, Tim Littler
Optimization Of Frt Active Power Performance Of A Dfig During Transient Grid Faults, L Meegahapola, Damian Flynn, Tim Littler
Dr Lasantha G Meegahapola
Optimal fault ride-through (FRT) conditions for a doubly-fed induction generator (DFIG) during a transient grid fault are analyzed with special emphasis on improving the active power generation profile. The transition states due to crowbar activation during transient faults are investigated to exploit the maximum power during the fault and post-fault period. It has been identified that operating slip, severity of fault and crowbar resistance have a direct impact on the power capability of a DFIG, and crowbar resistance can be chosen to optimize the power capability. It has been further shown that an extended crowbar period can deliver enhanced inertial …
Optimization Of Welding Parameters For Repairing Nial Bronze Components, Huijun Li, Daniel Grudgings, Nathan P. Larkin, John Norrish, Mark Callaghan, Lenka Kuzmikova
Optimization Of Welding Parameters For Repairing Nial Bronze Components, Huijun Li, Daniel Grudgings, Nathan P. Larkin, John Norrish, Mark Callaghan, Lenka Kuzmikova
Nathan Larkin
The objective of this study is to determine an optimal welding procedure that can be implemented to repair damaged Nickel Aluminium Bronze (NAB) components. NAB is commonly used in marine applications where components are subject to a constant corrosive environment and high stresses. Research into ideal NAB microstructure for a marine application, was performed in order to gain a baseline for experimental analysis of potential welding procedures. The results indicated that the welding repair can be performed with a wide range of heat input. The effect of post-weld heat treatment (PWHT) on the microstructure and mechanical properties in the heat …