Engineering Commons^™

Influence Of Tip Clearance On The Flowfield In A Compressor Cascade With A Moving Endwall, Richard J. Mcmullan

Theses and Dissertations

The effects of changing the blade tip clearances on the velocity and pressure flowfields within a compressor cascade were investigated in this experimental thesis. All moving endwall measurements were taken at a constant flow coefficient of 0.5 and tip clearances of 0.5, 1.0 and 2.0 percent chord. Hot-wire/film probes were used to determine the three-dimensional velocity vector components in various transverse planes - one upstream of the leading edges of the blades, three within the blade cascade and one downstream of the trailing edges of the blades. The transverse velocity vector plots showed a scraping of the tip leakage vortex …

Multidisciplinary And Multiobjective Optimization In Conceptual Design For Mixed-Stream Turbofan Engines, Luc J. J. P. Nadon

Theses and Dissertations

Despite major advances in design tools such as engine cycle analysis software and computer aided design, conceptual gas turbine engine design is essentially a trial-and-error process based on the experience of engineers. Modern optimization concepts, such as multidisciplinary optimization (MDO), and multiobjective optimization (MOO), linked with sequential quadratic programming (SQP) methods and genetic algorithms (GA), were applied to the conceptual engine design process to automate the conceptual design phase. Robust integrated computer codes were created to find the optimal values of eight engine parameters in order to minimize fuel usage, aircraft cost and engine annulus area over a given mission. …

The Design, Fabrication, And Evaluation Of A Low-Speed, Low-Turbulence, Anechoic Wind Tunnel, Brian J. Kaplan

Master's Theses - Daytona Beach

In order to provide a means for testing noise reduction techniques in propellers and fans, a low-speed, low-turbulence, anechoic wind tunnel was designed, fabricated and evaluated at Embry-Riddle Aeronautical University.

This open circuit wind tunnel was designed using several other existing wind tunnels as a guide and incorporated an open jet test section. The tunnel, which was built almost entirely out of wood and fiberglass, is powered by a 15 hp centrifugal fan.

Tufts of yarn, a pitot-static tube, and a hot film anemoter were used to determine the flow characteristics in the test section of this wind tunnel. From …