Engineering Commons^™

Adhesion And Deformation Mechanisms Of Polydopamine And Polytetrafluoroethylene: A Multiscale Computational Study, Matthew Brownell

Graduate Theses and Dissertations

Polydopamine (PDA) has been shown to bond via covalent bonding, van der Waals forces, and hydrogen bonding and is known to adhere strongly to almost any material. The application of PDA between a substrate and a PTFE surface coating has resulted in low friction and a greatly reduced wear rate. Previous research probing the capabilities and limitations of PDA/PTFE films have studied the wear and mechanical properties of the film, but the overall adhesive and deformation mechanisms remain unclear.

In this research, we investigate the tribological properties of PDA and PTFE molecules and composites from the atomic to the microscale …

Wear Resistant Polydopamine/Ptfe Nanoparticle Composite Coating For Dry Lubrication Applications, Samuel George Beckford

Graduate Theses and Dissertations

This dissertation presents an investigation into the effect of nanoparticle fillers and a polydopamine adhesive primer on the tribological performance of thin PTFE films. The principal objective of this investigation was to reduce wear in PTFE films, an issue which precludes the use of PTFE films in tribological applications requiring high durability. The friction and wear of the composite films were evaluated using a ball-on-flat configuration in linear reciprocating motion. It was found that the use of a polydopamine adhesive primer reduces the wear of PTFE films more than 600 times. X-ray photoelectron spectroscopy (XPS) results show that a tenacious …

Friction And Adhesion In Rigid Surface Indentation Of Nitrile Rubber, Stephen Jerrams

Articles

When a rigid body in the form of a plane strain indentor is forced into an elastomer, the asperities on the surface of the indentor are filled by the softer material. As depth of ingress increases, the rubber displaced into the indentor asperities exhibits stick-slip behaviour. The rubber adheres to the rigid body and if the depth of ingress is held at a maximum, the level of adhesion remains constant despite short-term load relaxation occurring in the rubber.

This text describes the influence of a range of factors on indentation forces and adhesion in rigid indentation of hydrogenated nitrile rubbers. …