Open Access. Powered by Scholars. Published by Universities.®
- Keyword
- Publication
- Publication Type
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Stimulated Brillouin Scattering Continuous Wave Phase Conjugation In Step-Index Fiber Optics, Steven M. Massey, Justin B. Spring, Timothy H. Russell
Stimulated Brillouin Scattering Continuous Wave Phase Conjugation In Step-Index Fiber Optics, Steven M. Massey, Justin B. Spring, Timothy H. Russell
Faculty Publications
Continuous wave (CW) stimulated Brillouin scattering (SBS) phase conjugation in step-index optical fibers was studied experimentally and modeled as a function of fiber length. A phase conjugate fidelity over 80% was measured from SBS in a 40 m fiber using a pinhole technique. Fidelity decreases with fiber length, and a fiber with a numerical aperture (NA) of 0.06 was found to generate good phase conjugation fidelity over longer lengths than a fiber with 0.13 NA. Modeling and experiment support previous work showing the maximum interaction length which yields a high fidelity phase conjugate beam is inversely proportional to the fiber …
Tightly Integrating Optical And Inertial Sensors For Navigation Using The Ukf, Sedat Ebcin
Tightly Integrating Optical And Inertial Sensors For Navigation Using The Ukf, Sedat Ebcin
Theses and Dissertations
The motivation of this research is to address the benefits of tightly integrating optical and inertial sensors where GNSS signals are not available. The research begins with describing the navigation problem. Then, error and measurement models are presented. Given a set of features, a feature detection and projection algorithm is developed which utilizes inertial measurements to predict vectors in the feature space between images. The unscented Kalman filter is applied to the navigation system using the inertial measurements and feature matches to estimate the navigation trajectory. Finally, the image-aided navigation algorithm is tested using a simulation and an experiment. As …
Demonstration Of A Strategy To Perform Two-Dimensional Diode Laser Tomography, Ryan N. Givens
Demonstration Of A Strategy To Perform Two-Dimensional Diode Laser Tomography, Ryan N. Givens
Theses and Dissertations
Demonstration of a strategy to perform two-dimensional diode laser tomography using a priori knowledge from symmetry arguments and computational fluid dynamic (CFD) calculations is presented for a flat flame burner. The strategy uses an optimization technique to determine flame diameter and location using a vector quantization approach. Next, the variance in a training set, produced from CFD calculations, is captured using principal components analysis. The information in the training set allows interpolation between beam paths resulting in temperature and density maps. Finally, the TDLAS temperature and density maps are shown to agree with traditional thermocouple measurements of the flat flame …
Performance Comparison Of Pb(Zr0.52Ti0.48)O3-Only And Pb(Zr0.52Ti0.48)O3-On-Silicon Resonators, Hengky Chandrahalim, Sunil A. Bhave, Ronald G. Polcawich, Jeff Pulskamp, Dan Judy, Roger Kaul, Madan Dubey
Performance Comparison Of Pb(Zr0.52Ti0.48)O3-Only And Pb(Zr0.52Ti0.48)O3-On-Silicon Resonators, Hengky Chandrahalim, Sunil A. Bhave, Ronald G. Polcawich, Jeff Pulskamp, Dan Judy, Roger Kaul, Madan Dubey
Faculty Publications
This paper provides a quantitative comparison and explores the design space of lead zirconium titanate (PZT)–only and PZT-on-silicon length-extensional mode resonators for incorporation into radio frequency microelectromechanical system filters and oscillators. We experimentally measured the correlation of motional impedance (RX) and quality factor (Q) with the resonators’ silicon layer thickness (tSi). For identical lateral dimensions and PZT-layer thicknesses (tPZT), the PZT-on-silicon resonator has higher resonant frequency (fC), higher Q (5100 versus 140), lower RX (51 Ω versus 205 Ω), and better linearity [third-order input intercept …