Engineering Commons^™

Phase Gradient Algorithm Method For 3-D Holographic Ladar Imaging, Jason W. Stafford, Bradley D. Duncan, David J. Rabb

Bradley D. Duncan

3-D holographic ladar uses digital holography with frequency diversity to add the ability to resolve targets in range. A key challenge is that since individual frequency samples are not recorded simultaneously, differential phase aberrations may exist between them making it difficult to achieve range compression. We describe steps specific to this modality so that phase gradient algorithms (PGA) can be applied to 3-D holographic ladar data for phase corrections across multiple temporal frequency samples. Substantial improvement of range compression is demonstrated with a laboratory experiment where our modified PGA technique is applied. Additionally, the PGA estimator is demonstrated to be …

Phase Gradient Algorithm Method For 3-D Holographic Ladar Imaging, Jason W. Stafford, Bradley D. Duncan, David J. Rabb

Electro-Optics and Photonics Faculty Publications

3-D holographic ladar uses digital holography with frequency diversity to add the ability to resolve targets in range. A key challenge is that since individual frequency samples are not recorded simultaneously, differential phase aberrations may exist between them making it difficult to achieve range compression. We describe steps specific to this modality so that phase gradient algorithms (PGA) can be applied to 3-D holographic ladar data for phase corrections across multiple temporal frequency samples. Substantial improvement of range compression is demonstrated with a laboratory experiment where our modified PGA technique is applied. Additionally, the PGA estimator is demonstrated to be …

Heterodyne Ladar System Efficiency Enhancement Using Single-Mode Optical Fiber Mixers, Donald K. Jacob, Martin B. Mark, Bradley D. Duncan

Bradley D. Duncan

A theoretical performance analysis of a heterodyne ladar system incorporating a single-mode fiber receiver has been performed. For our purposes, the performance parameters of interest are the coupling and mixing efficiency of the ladar receiver, as they relate to the overall system carrier-to-noise ratio. For a receiver incorporating a single-mode fiber mixer, the received and local-oscillator fields are matched both spatially and temporally at the detector, yielding 100% mixing efficiency. We have therefore focused our efforts on determining an expression for the efficiency with which a diffuse return from a purely speckle target can be coupled into the receiving leg …

Algorithm Development Of The Aglite-Lidar Instrument, Christian Marchant

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Particulate emissions from agricultural operations are increasingly receiving attention from regulatory bodies as a potential source of air pollution. The Space Dynamics Laboratory (SDL) has developed the Aglite system, a suite of instruments including a lidar that is capable of measuring particulate emission levels from agricultural facilities. This system provides a novel method of measuring particulate mass (PM) pollution, allowing measurements to be taken of diverse types of facilities with high temporal and spatial resolution. This high resolution allows for the measurement of emission levels generated by specific activities, fostering the development and determination of best management practices.

The Aglite …

Development Of An Efficient Ti:Sapphire Laser Transmitter For Atmospheric Ozone Lidar Measurements, Khaled A. Elsayed

Electrical & Computer Engineering Theses & Dissertations

The impetus of this work was to develop an all solid-state Ti:sapphire laser transmitter to replace the current dye lasers that could provide a potentially compact, robust, and highly reliable laser transmitter for differential absorption lidar measurements of atmospheric ozone. Two compact, high-energy pulsed, and injection-seeded Ti:sapphire lasers operating at a pulse repetition frequency of 30 Hz and wavelengths of 867 nm and 900 nm, with M² of 1.3, have been experimentally demonstrated and compared to model results. The Ti:sapphire lasers have shown the required output beam quality at maximum output pulse energy, 115 mJ at 867 nm and …

Coherent Differential Absorption Lidar For Combined Measurement Of Wind And Trace Atmospheric Gases, Grady James Koch

Electrical & Computer Engineering Theses & Dissertations

A lidar system was developed for making combined range-resolved measurements of wind speed and direction, water vapor concentration, and carbon dioxide concentration in the atmosphere. This lidar combines the coherent Doppler technique for wind detection and the differential absorption lidar (DIAL) technique to provide a multifunctional capability. DIAL and coherent lidars have traditionally been thought of and implemented as separate instruments, but the research reported here has shown a demonstration of combining the coherent and DIAL techniques into a single instrument using solid-state lasers. The lasers used are of Ho:Tm:YLF, which operates at a wavelength of 2 μm. This wavelength …

Heterodyne Ladar System Efficiency Enhancement Using Single-Mode Optical Fiber Mixers, Donald K. Jacob, Martin B. Mark, Bradley D. Duncan

Electro-Optics and Photonics Faculty Publications

A theoretical performance analysis of a heterodyne ladar system incorporating a single-mode fiber receiver has been performed. For our purposes, the performance parameters of interest are the coupling and mixing efficiency of the ladar receiver, as they relate to the overall system carrier-to-noise ratio. For a receiver incorporating a single-mode fiber mixer, the received and local-oscillator fields are matched both spatially and temporally at the detector, yielding 100% mixing efficiency. We have therefore focused our efforts on determining an expression for the efficiency with which a diffuse return from a purely speckle target can be coupled into the receiving leg …