Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Operations Research, Systems Engineering and Industrial Engineering

Louisiana State University

Theses/Dissertations

2006

Emg

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Effect Of Repetitions On Static And Dynamic Strength, Sai Chaitanya Reddy Bogolu Jan 2006

Effect Of Repetitions On Static And Dynamic Strength, Sai Chaitanya Reddy Bogolu

LSU Master's Theses

The objective of this study was to investigate the effect of repetitions on static and dynamic strength. The study is divided into two parts, the first part investigated static and dynamic strength during one, three and six repetitions per minute, and the second part of the study analyzed dynamic strength data collected using the Multiaxial Multipurpose Isokinetic Dynamometer. The study comprised of dynamic strength test data at three speeds of one, five and ten inch per second. Five male subjects participated in the first part of the study, and the results were analyzed by plotting a time series to observe …


Effect Of Overhead Drilling Support On Muscular Activity Of Shoulder, Bharat Kumar Bhogaraju Bhallam Venkata Jan 2006

Effect Of Overhead Drilling Support On Muscular Activity Of Shoulder, Bharat Kumar Bhogaraju Bhallam Venkata

LSU Master's Theses

This study examines the effect of an overhead drilling support and position of the arm on muscular activity of the shoulder. Five male participants simulated an overhead drilling task by using a drill in near, middle and far reach positions. Electromyographic measurements were taken from the dominant side anterior deltoid, bicep and trapezius muscles. Root mean square amplitude (RMS) of the EMG activity from these muscles was used to determine the load on the muscular system. The participants used a subjective rating scale to evaluate the overhead support stand and holding position. The results demonstrate that the overhead support stand …