Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Engineering
Factors Affecting The Quality Of Dry Shotcrete, El Rasheid Mohamed Abdalla El Khidir
Factors Affecting The Quality Of Dry Shotcrete, El Rasheid Mohamed Abdalla El Khidir
Archived Theses and Dissertations
No abstract provided.
Computational Investigation Of Aeromechanical Hcf Effects In A Compressor Rotor, Andrew L. White
Computational Investigation Of Aeromechanical Hcf Effects In A Compressor Rotor, Andrew L. White
Theses and Dissertations
High-Cycle Fatigue is a major problem facing the gas turbine industry today. It has been investigated by many researchers, using many different methods. Due to its highly complex nature, designers still do not have adequate tools to accurately predict the onset of high-cycle fatigue. A three-dimensional Navier-Stokes program was used to perform a study of the unsteady aerodynamics on a compressor rotor. The effect of aerodynamic detuning on the forced response of a rotor blade was compared to a baseline tuned rotor case. Detuning consisted of a ten percent decrease in circumferential spacing between alternate pairs of blades. The high-cycle …
Fatigue Response Of Thin Stiffened Aluminum Cracked Panels Repaired With Bonded Composite Patches, Jason B. Avram
Fatigue Response Of Thin Stiffened Aluminum Cracked Panels Repaired With Bonded Composite Patches, Jason B. Avram
Theses and Dissertations
This research investigated the fatigue response of precracked and patched 2024-T3 Aluminum panels with stiffeners. Patches were single-sided, unidirectional three ply boron/epoxy. Stiffeners were 2024-T3 aluminum and were riveted and bonded on. Disbonds were introduced into the repair bondline by inserting teflon strips. Three disbond configurations were investigated rack tip disbond (CTD) located at the edge of the patch in the path of crack propagation, full-width disbond (FWD) covering the entire crack, and end disbond (ED) located at each end of the patch and covering the full width. Each repaired panel was subjected to tension/tension cyclic fatigue with a maximum …
Modification Of Position And Attitude Determination Of A Test Article Through Photogrammetry To Account For Structural Deformation, Sean A. Krolikowski
Modification Of Position And Attitude Determination Of A Test Article Through Photogrammetry To Account For Structural Deformation, Sean A. Krolikowski
Theses and Dissertations
This study improved the current method of position and attitude determination to account for structural deformation of the wind tunnel test article due to aerodynamic loading. To account for deformation, parabolic bending and linear twisting coefficients were added into the Levenberg-Marquardt multi-parameter solver. By accounting for deformation, the accuracy of position and attitude determination was greatly improved. This study also takes a qualitative look at the optimum number of wind tunnel cameras and model targets. Optimal configuration was found to be around 50 targets and 2 cameras offset by 90 degrees.
The Development Of A Finite Element Program To Model High Cycle Fatigue In Isotropic Plates, William C. Shipman
The Development Of A Finite Element Program To Model High Cycle Fatigue In Isotropic Plates, William C. Shipman
Theses and Dissertations
As part of a joint AFRL/DAGSI turbine blade research effort, a computer program has been developed that uses a von Karman large-deflection two-dimensional finite element approximation to determine stress levels and patterns in isotropic thin plates. The dynamic loading of various plates has been carried out in order to model a high cycle fatigue situation. The research considered the various effects of mode shapes, resident frequency, non-linear cyclic effect, endurance limits, and stress variations within a high cycle fatigue environment. Two main initiatives were taken. First, a transient analysis tool was developed that calculates stress and displacement patterns over a …