Engineering Commons^™

Sample Size Effect On Combustion Analysis, Osueke C. O, Uguru Okorie Daniel, Aondoyila Kuhe

Innovative Research Publications IRP India

Engine parameters vary from one cycle to the other and this makes engine analysis with data from a single working cycle insufficient in capturing or modelling an engine behaviour. The variation observed in engine has necessitated the use sample sizes of data obtained during an engine operation to obtain results that are representative of the engine being investigated. Research has shown that the use of very large data sample size increases the storage needed and processing time and does not necessary give better results over results obtained with lesser sample sizes. The number of sample size to use for analysis …

Effect Of N-Butanol And Diethyl Ether As Oxygenated Additives On Combustion-Emission-Performance Characteristics Of A Multiple Cylinder Diesel Engine Fuelled With Diesel-Jatropha Biodiesel Blend

Faculty of Engineering University of Malaya

Jatropha biodiesel is considered as one of the most prospective renewable energy sources of Malaysia in recent years. Hence, an investigation was conducted for the improvement of jatropha biodiesel-diesel blend with the addition of 5-10% n-butanol and diethyl ether by vol. which are commonly known as oxygenated cold starting additive. Engine tests were conducted at variable speed, ranging from 1000 rpm to 3000 rpm at constant 80 N m torque on a 4-cylinder turbocharged indirect injection diesel engine. Engine performance parameters like brake specific fuel consumption, brake specific energy consumption, brake thermal efficiency and engine emissions like carbon monoxide, unburned …

La0.7Sr0.3Fe0.7Ga0.3O3-Δ As Electrode Material For A Symmetrical Solid Oxide Fuel Cell, Zhibin Yang, Yu Chen, Chao Jin, Guoliang Xiao, Minfang Han, Fanglin Chen

Fanglin Chen

In this research, La_0.7Sr_0.3Fe_0.7Ga_0.3O_3−δ (LSFG) perovskite oxide was successfully prepared using a microwave-assisted combustion method, and employed as both anode and cathode in symmetrical solid oxide fuel cells. A maximum power density of 489 mW cm⁻² was achieved at 800 °C with wet H₂ as the fuel and ambient air as the oxidant in a single cell with the configuration LSFG|La_0.8Sr_0.2Ga_0.83Mg_0.17O_3−δ|LSFG. Furthermore, the cells demonstrated good stability in H₂ and acceptable sulfur tolerance.

Characterization And Prediction Of Blend Properties And Evaluation Of Engine Performance And Emission Parameters Of A Ci Engine Operated With Various Biodiesel Blends

Faculty of Engineering University of Malaya

The present research is aimed to investigate the feasibility of using palm (PB), mustard (MB) and Calophyllum biodiesel (CB) as renewable and alternative fuels. Biodiesels were produced from the respective crude vegetable oils and physicochemical properties of the biodiesel-diesel blends were graphically compared for all possible biodiesel blends at every 10% composition interval. By applying the curve-fitting method, equations were developed for predicting important properties, which show very close fit to the experimental data. This will help future research such as the optimization of blending percentage, engine combustion and performance and emission analysis. As up to 20% blends of biodiesels …

State Of The Art / Novel Rotary-Turbo-Inflow Tech / Featured Development - Gearturbine Project - Atypical Motor Engine Type, Carlos Barrera

Carlos Barrera

GEARTURBINE PROJECT Atypical InFlow Thermodynamic Technology Proposal Submission Novel Fueled Motor Engine Type

*State of the art Innovative concept Top system Higher efficient percent. Have similar system of the Aeolipile Heron Steam device from Alexandria 10-70 AD. -New Form-Function Motor-Engine Device. Next Step, Epic Design Change, Broken-Seal Revelation. -Desirable Power-Plant Innovation.

YouTube; * Atypical New • GEARTURBINE / Retrodynamic = DextroRPM VS LevoInFlow + Ying Yang Thrust Way Type - Non Waste Looses

-This innovative concept consists of hull and core where are held all 8 bteps of the work-flow which make the concept functional. The core has several gears …

Lectio Praecursoria, Kari Myöhänen

Kari Myöhänen

Lectio praecursoria: Modelling of combustion and sorbent reactions in three-dimensional flow environment of a circulating fluidized bed furnace

Dual-Pump Dual-Broadband Coherent Anti-Stokes Raman Scattering In Reacting Flows, Sukesh Roy, Terrence R. Meyer, Robert P. Lucht, Mikael Afzelius, Per-Erik Bengtsson, James R. Gord

Terrence R Meyer

A dual-pump, dual-broadband coherent anti-Stokes Raman scattering system for simultaneous measurements of temperature and concentrations of N2, O2, and CO2 in reacting f lows is demonstrated. In this system pure rotational transitions of N2 O2 and rovibrational transitions of N2 CO2 are probed simultaneously with two narrowband pump beams, a broadband pump beam, and a broadband Stokes beam. The main advantage of this technique is that it permits accurate temperature measurements at both low and high temperatures as well as concentration measurements of three molecules.

Novel Rotary-Turbo-Inflow Tech - Gearturbine Project - Featured Development, Carlos Barrera

Carlos Barrera

GEARTURBINE PROJECT Atypical InFlow Thermodynamic Technology Proposal Submission Novel Fueled Motor Engine Type

*State of the art Innovative concept Top system Higher efficient percent. Have similar system of the Aeolipile Heron Steam device from Alexandria 10-70 AD. -New Form-Function Motor-Engine Device. Next Step, Epic Design Change, Broken-Seal Revelation. -Desirable Power-Plant Innovation.

YouTube; * Atypical New • GEARTURBINE / Retrodynamic = DextroRPM VS LevoInFlow + Ying Yang Thrust Way Type - Non Waste Looses

-This innovative concept consists of hull and core where are held all 8 bteps of the work-flow which make the concept functional. The core has several gears …