Engineering Commons^™

Experimental Study Of The Chimney Height Variation Against Double Pots Biomass Stove Performance, Faisal Faisal, Adi Setiawan, Wusnah Wusnah, Khairil Khairil, Luthfi Luthfi, Mona Fajriana

Makara Journal of Technology

This research aims to get optimal chimneys height of double pots biomass stove. Optimal chimneys height needs to provide best performance of the stove. Experimental study was done by varied the chimney heights. Water boiling test as the standard method was used to obtained stove performance for each chimney height variation. The results showed that best performance stove was the one with 1.65 cm chimney height, with thermal efficiency at 37.66%.

Marine Biomass Analyzer, Kai Jay Staal, Brian Paris, Tyler Cottle

Mechanical Engineering

This report documents the design, fabrication, and testing for a marine biomass analyzer. The goal of the project and constructed system was to determine the validity and efficacy of a process that could flatten benthic macrofauna to a consistent thickness such that a biomass for the collected sample could be accurately determined. The system that was built and tested consists of a drive train that turns a mill subassembly where the organisms are flattened, supply and collection spools that hold the white fabric and clear film used to capture the organisms, a collection zone where the sample is injected, and …

An Analytical Model To Predict The Length Of Oxygen-Assisted, Swirled, Coal And Biomass Flames, David Arthur Ashworth

Theses and Dissertations

Government regulations to reduce pollutants and increasing environmental awareness in the power generation industry have encouraged coal power plants to begin firing biomass in their boilers. Biomass generally consists of larger particles which produce longer flames than coal for a given burner. The length of the flame is important in fixed-volume boilers because of its influence on heat transfer, corrosion, deposition, and pollutant formation. Many pulverized fuel burners employ a series of co-annular tubes with various flows of fuel and air to produce a stabilized flame. A variable swirl burner with three co-annular tubes, each of variable diameter, has been …

Heat Transfer Analysis In A Paddle Reactor For Biomass Fast Pyrolyis, Ankith Ullal

Dissertations, Master's Theses and Master's Reports

Heat transfer analysis was performed on a novel auger reactor for biomass fast pyrolysis. As part of this analysis, correlations for specific heat capacity and heat transfer coefficients for biomass (sawdust) and sand (used as heat transfer medium) were developed. For sand, the heat transfer coefficient followed a power law distribution with reactor fill level and temperature. For raw biomass, the heat transfer coefficient also showed similar dependence on fill level, but was independent of temperature up to 300°C. These correlations were used in a one dimensional heat transfer model developed to calculate the heating time and heating rate of …

Development Of Heterogeneous Catalysts For Upgrading Biomass Pyrolysis Bio-Oils Into Advanced Biofuels, Shouyun Cheng

Electronic Theses and Dissertations

The massive consumption of fossil fuels and associated environmental issues result in an increased interest in alternative resources such as biofuels. The renewable biofuels can be upgraded from bio-oils that are derived from biomass pyrolysis. Catalytic cracking and hydrodeoxygenation (HDO) are two most promising bio-oil upgrading techniques for biofuel production. Heterogeneous catalysts are essential for upgrading bio-oil into hydrocarbon biofuel. Although some progresses have been made, the cost and effectiveness of catalysts still remain challenges. The main objective of this study was to develop efficient heterogeneous catalysts for upgrading bio-oils into advanced hydrocarbon biofuel with low costs. In catalytic cracking, …

Impact Of Pretreatment Methods On Fast Pyrolysis Of Biomass, Yash Donepudi

Dissertations, Master's Theses and Master's Reports

Biomass is considered a renewable source of energy with minimum carbon foot print if managed sustainably. The majority of the worlds energy is spend on transportation, and fast pyrolysis of biomass could be a potential route for production of a sustainable liquid transportation fuel. However, there are several hurdles in the conversion process. This work addresses these hurdles by investigating the impact of several pretreatment methods on fast pyrolysis including thermal pretreatment (torrefaction), comminution/grinding, mineral reduction. The impact of important parameters like heat transfer medium, conversion temperature and particle size were also investigated.

A mild thermal pretreatment of biomass (~10-15% …

Co-Gasification Of Coal And Biomass Wastes In An Entrained Flow Gasifier: Modelling, Simulation And Integration Opportunities, Dalia A. Ali Eng, Mamdouh A. Gadalla Prof., Omar Y. Abdelaziz, Christian P. Hulteberg, Fatma H. Ashour Prof.

Chemical Engineering

Gasification processes convert carbon-containing material into syngas through chemical reactions in the presence of gasifying agents such as air, oxygen, and steam. Syngas mixtures produced from such processes consist mainly of carbon monoxide (CO), hydrogen (H2), carbon dioxide (CO2), and methane (CH4); this gas can be directly utilised as a fuel to produce electricity or steam. Besides, it is regarded as a basic feedstock within the petrochemical and conventional refining industries, producing various useful products like methanol, hydrogen, ammonia, and acetic acid. In this work, a rigorous process model is developed to simulate the co-gasification of coal-biomass blends through an …