Engineering Commons^™

Nanosphere Lithography And Its Application In Rapid And Economic Fabrication Of Plasmonic Hydrogenated Amorphous Silicon Photovoltaic Devices, Chenlong Zhang

Dissertations, Master's Theses and Master's Reports

Solar photovoltaic (PV) devices harvest energy from solar radiation and convert it to electricity. PV technologies, as an alternative to traditional fossil fuels, use clean and renewable energy while minimizing pollution. For decades researchers have been developing thin film solar cells as an important alternatives to the relatively expensive bulk crystal solar cell technology. Among those, hydrogenated amorphous silicon (a-Si:H) solar cells prevails for good efficiency, non-toxic and materially abundant nature. However, a-Si:H thickness must be minimized to prevent light induced degradation, so optical enhancement is necessary. Light manipulation has to be applied and carefully engineered to trap light within …

Fabrication And Characterization Of Microcrystalline Silicon Solar Cells, Liwei Li

Dissertations

In this study, single junction p-i-n μc-Si:H solar cells were prepared using plasma of silane diluted by hydrogen in a low-cost, single chamber, non-load-locked RF-PECVD system. Direct structural characterization of μc-Si:H solar cells, rather than stand-alone films, was conducted using Raman Spectroscopy, XRD, and AFM. Strong correlations among device deposition, i-layer structural properties, and device performance have been established. With such correlations, critical issues in fabricating low-cost, large-scale, high performance μc-Si:H solar cells were identified.

The critical importance of seeding processes in determining the microstructure of μc-Si:H i-layers and performance of μc-Si:H solar cells has been demonstrated. Using …