Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Engineering

Development Of Flexible Nickel-Zinc And Nickel-Iron Batteries, Xianyang Meng Dec 2018

Development Of Flexible Nickel-Zinc And Nickel-Iron Batteries, Xianyang Meng

Dissertations

The fabrication of flexible nickel-zinc batteries using a facile mixing of electroactive components for electrode preparation is presented. Polytetrafluoroethylene (PTFE) is found to be an effective binder by reducing concentration polarization, providing chemical/physical stability and enhancing flexibility. The zinc electrode containing PTFE maintains its original porous morphology even after hundreds of cycles while polymers such as PEO show morphology change. Each component, as well as the assembled flexible cells show desired flexibility and stability even under bending conditions.

The fabrication of flexible nickel-iron batteries using printable composite electrodes embedded with multiwalled carbon nanotubes (CNT) is also presented. All the metal …


Corrosion Dynamics Of Carbon Steel In Used Fuel Container Environments, Dan Guo Dec 2018

Corrosion Dynamics Of Carbon Steel In Used Fuel Container Environments, Dan Guo

Electronic Thesis and Dissertation Repository

The current Canadian used nuclear fuel container (UFC) design uses a pressure‑grade carbon steel (CS) vessel with its outer surface coated with a thin layer of copper. One concern regarding the structural integrity of the UFC design is the potential internal corrosion of the CS vessel. Moisture trapped inside a UFC could condense within the gap between the hemispherical head and the cylindrical body of the vessel. The internal UFC environment will be exposed to a continuous flux of ionizing radiation arising from the decay of radionuclides trapped in the used UO2 fuel matrix.

This thesis research project investigates …


Design And Synthesis Of Novel Nanometallic Catalysts And Electrode Materials For Green Fuel Cells, Jing Zhang May 2018

Design And Synthesis Of Novel Nanometallic Catalysts And Electrode Materials For Green Fuel Cells, Jing Zhang

Graduate Dissertations and Theses

The United Nations formally adopted 17 sustainable development goals (SDGs) at its 2015 summit. Many of these goals addressed issues such poverty, hunger, health, education, climate-change, gender equality, water, sanitation, energy, urbanization, environment and social justice. The seventh SDG seeks to ensure access to affordable, reliable, sustainable and modern energy for all. So among all renewable forms of energy, fuel cells with high efficiency have attracted a lot of attention recently. In particular, the direct ethanol fuel cells (DEFCs) and microbial fuel cells (MFCs) are significant due to their green fuel, less waste generated and environmental friendliness. Hence the overall …


Non-Precious Metal Catalysts For Oxygen Reduction Reaction In Alkaline Solutions, Zhewen Yin Mar 2018

Non-Precious Metal Catalysts For Oxygen Reduction Reaction In Alkaline Solutions, Zhewen Yin

USF Tampa Graduate Theses and Dissertations

Mesoporous WO3 powders were prepared via sol-gel processing synthesis using nonionic surfactant Pluronic (P-123) as the template. The influences of heating temperature on the pore structure and properties of WO3 powders were investigated. Three kinds of modifications were compared and evaluated after finding out the best heating condition. Different amount of lanthanum was doped into mesoporous WO3 to improve its Oxygen Reduction Reaction (ORR) activity. Several factors contributing to the increase of catalytic performance were discussed. Vulcan carbon powder was also used as a support to increase the catalysts’ electrical conductivity as well as dispersity. The component, microstructure and specific …


Corrosion Performance Of Zirconium-Based Passivations On Electroplated Zinc Nickel, Madison Morgan Reed Jan 2018

Corrosion Performance Of Zirconium-Based Passivations On Electroplated Zinc Nickel, Madison Morgan Reed

Masters Theses

“Performance requirements for Department of Defense (DoD) electrical components include corrosion and electrical contact resistance. Historically, electroplated cadmium with a chromate conversion coating (CrCC) has been used to meet corrosion and contact resistance standards. However, replacements are needed for these materials because they are toxic and carcinogenic. Electroplated γ-ZnNi has been identified as an acceptable alternative to Cd. This study evaluated commercially available Zr-based thin films and sealers as passivations for potential replacement of CrCCs. Ten different passivations were tested and compared with bare γ-ZnNi. X-Bond and Zircobond passivations were found to provide some improvement to the bare ZnNi corrosion …