Engineering Commons^™

Investigation Of Electrolyte Wetting In Lithium Ion Batteries: Effects Of Electrode Pore Structures And Solution, Yangping Sheng

Theses and Dissertations

Beside natural source energy carriers such as petroleum, coal and natural gas, the lithium ion battery is a promising man-made energy carrier for the future. This is a similar process evolved from horse-powered era to engine driven age. There are still a lot of challenges ahead like low energy density, low rate performance, aging problems, high cost and safety etc.

In lithium ion batteries, investigation about manufacturing process is as important as the development of material. The manufacturing of lithium ion battery, including production process (slurry making, coating, drying etc.), and post-production (slitting, calendering etc.) is also complicated and critical …

Feasibility Study Of Custom Manufacturing Of Ionic Polymer-Metal Composite Sensors, Shelby E. Nelson

UNLV Theses, Dissertations, Professional Papers, and Capstones

The ability to create an ion exchange membrane with any shape or thickness through custom manufacturing techniques is highly desirable in ionic polymer-metal composite (IPMC) research. This is caused by the poor selection and limited availability of certain thicknesses of commercial ion exchange membranes. The objective of this study is to determine the feasibility of manufacturing custom ion exchange membranes for IPMC sensors. The manufacturing methods used in this study are extrusion, injection molding, and hot pressing. A commercial membrane from Golden Energy Fuel Cells (GEFC) is used as a comparison. After the membranes are fabricated, certain properties of the …

Analysis Of Compression Creep Deformation Of 7050 Aluminum Large Scale Open Die Forgings During The Solution Heat Treatment Process, Ashley Lopez, Elysha Cole

Materials Engineering

A stress, ranging from 104.17 to 166.67 psi, was applied to 0.5 in diameter cylindrical samples of 7050 aluminum using a manufactured fixture that applies stress using an indenter with a diameter of 0.127 in. The stress range used replicates the stresses produced on large scale forgings weighing up to 4000 lbs. We chose a maximum, medium and low stress as our stress parameters. The samples were placed into the fixture for stability then placed in a furnace heated to 890°F which is the solution heat treatment temperature for 7050 aluminum. The heat treatment times varied between 4 and 24 …