Engineering Commons^™

Statistical Analysis Of X-40 (Stellite-31) Production Blends., Edward P. Patterson

Masters Theses

"An investigation was undertaken to statistically analyze the data obtained on X-40 (Stellite 31) production blends which were tested to the requirements of AMS 5382. For our purpose a blend is one or more furnace heats, the shot of which has been thoroughly mixed to produce greater uniformity of product. The mixed shot is charged to the arc furnaces and cast into parts, and test specimens. A great range of test results have been obtained in testing blends, and it was felt that a statistical analysis of a few of the variables might yield information which could be applied toward …

Determination Of Lattice Constants, And Thermal Expansion Coefficients Of Ti₂O₃ And Of Its Solid Solutions With Ti, Tatsuhiko Ejima

Masters Theses

"For the determination of the precise lattice constants of Ti₂O₃, it is very important to use a Ti₂O₃ as pure as possible.

Due to the formation of solid solution with titanium or oxygen, ranging from 32.5 to. 34.5% O₂ by weight in the Ti-O binary system, it is very difficult to get a pure Ti₂O₃ (33.8% O₂ by weight) in the laboratory.

To determine the precise lattice constants of pure Ti₂O₃, therefore, the extrapolation method was used.

This method computes the respective constants for pure Ti₂O₃ from the values obtained With Ti₂O₃-Ti solid solutions by extrapolation. To carry out such …

Influence Of Some Metals On The Rate Of Corrosion And Deposition Of Titanium In Molten Salt Baths, Yu-Pu Huang

Masters Theses

"2. The purpose of this investigation. The substances obtained by corrosion of titanium in fused salts, if leached with water and dried, are composed of three kinds of products, namely of black, gray and yellowish ones. The black product was identified by X-ray diffraction as titanium-oxygen alloy with 9-10% by weight oxygen which later was used as coating material instead of the titanium sheet for deposition experiments described previously. The yellowish product was identified as rutile. The grayish product was also rutile but containing some titanium powder. Of these three products only the black one possessed the ability to deposit …

An Investigation Of The Dissolution Of Hafnium-Free Zirconium In Hydrofluoric Acid And The Effect Of Fluoride Additions, Alfred S. Neiman

Masters Theses

"Hafnium-free zirconium has assumed great importance in commercial use in recent years. When economical methods were developed in 1950 to remove hafnium from Zr, a metal was produced which not only exhibited good corrosion resistance and desirable physical properties, but also had a very low absorption cross section for thermal neutrons. Such a metal could obviously be utilized to advantage as a structural material for nuclear reactors. This application is the most important one for Zr at present.

Good corrosion resistance to most mineral acids is one of the outstanding non-nuclear properties of Zr. Hf-free Zr has good corrosion resistance …

Separation Of Iron-Tin Alloys Using Gas-Solid Reactions, Carl Richard Bieling

Masters Theses

"For years it has been a problem to the tin smelting, plating, and detinning industries to be able to separate iron from tin once they were associated together as described above. Due to the lack of a tin smelter in the United States in the past, and the abundance of tin scrap available, which had little value either for the iron content or the tin content in their untreated state, most interest was concentrated on seeking methods of separating this tin scrap into its two useful components, iron and tin, rather than deal with the problems of smelting tin from …