Engineering Commons^™

Modeling And Simulation Of Micro Electrical Discharge Machining Process, Bai Shao

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Micro parts and systems are playing crucial roles in the area of semiconductor, biomedical device, micro fluid devices, automotive, aerospace and so forth. Micro manufacturing is one of the most important technologies in realizing miniaturization. Compared to other micro manufacturing methods, micro-EDM is drawing lots of attention due to its ability to machine complex 3D parts regardless of the hardness of the workpiece material.

Micro-EDM is the cumulative result of numerous single discharges; therefore, it is crucial to understand the single discharge material removal process in micro-EDM. However, due to the stochastic nature and complex process mechanism, micro-EDM, including its …

A Case Study Of Multiple-Use Finish Electrodes For Die-Sinking Edm, Troy A. Robertson

Masters Theses & Specialist Projects

This study examines the use of one finishing electrode to finish multiple dies without remachining the electrode. The multiple-use electrode finishing experiment in this study addresses technology in the die-forging industry. Methods of manufacturing spherical straight bevel forge gear dies have relied on die-sinking Electrical Discharge Machining (EDM) practices that showed great potential for advancement. The focus of this study is solely on the improvements of electrode use in EDM finishing-processes. The surface finish quality itself is not an area of concern other than maintaining that it does not diminish. The focused concern is maximizing the process by using one …

Comparing The Feasibility Of Cutting Thin-Walled Sections From Five Commonly Used Metals Utilizing Wire Electric Discharge Machining, Richard C. Stephenson

Theses and Dissertations

Wire Electric Discharge Machining (wire-EDM) is a non-traditional machining process. Controlled electric sparks are successively used to vaporize part of a workpiece along a programmed path in order to machine a desired part. Because there is no tool that comes in direct contact with the workpiece, it is possible to machine thin, delicate parts. This thesis was designed to observe and analyze the differences in cutting capabilities for a conventional wire-EDM machine when cutting thin-walled sections from five commonly used metals utilizing a variation of roughing and finishing passes. The five metals that were used in this study are: Aluminum …