Engineering Commons^™

Valorization Of Xylan In Agroforestry Waste Streams, Harrison Appiah

Graduate Theses, Dissertations, and Problem Reports

Valorization of Xylan in Agroforestry Waste Streams.

Harrison Appiah

Microwave-assisted deep eutectic solvent and gamma-valerolactone metallic chloride catalyzed conversion of xylan to furfural were investigated using a 2x3 factorial experimental design at two levels of percent microwave power, reaction time, and catalyst concentration. The levels of each factor studied were (20%, 60% microwave power, 2, 4 minutes, and 10, 20mg) respectively. The effect of three metallic chloride catalysts (LiCl, FeCl3.6H20, CuCl2) on the conversion of xylan to furfural was also investigated. The gamma-valerolactone-ferric chloride sent system exhibited the highest mean yield of furfural (56.50%). The next highest furfural yield of …

Recovery Of Phosphorus From Florida Phosphatic Waste Clay, Amir Eskanlou

Graduate Theses, Dissertations, and Problem Reports

This MS thesis examines the recovery of phosphorus (P) from Florida waste clay (WC). A comprehensive literature review revealed that: (i)-The most important values being lost to WC are P and rare earth elements (REEs). For the recovery of these values from WC, two crucial attempts are the removal of extremely fine-sized clays, followed by the recovery of phosphate content, which can pave the path for the recovery of REEs; (ii)-Any scientific/ technological solution should, at the same time, be economically and environmentally attractive to the industry. As such, moving from mostly chemical separation processes to the primarily physical/ physicochemical …

Sustainability Assessment Of Direct Energy Deposition (Ded) Based Hybrid Manufacturing Using Life Cycle Assessment (Lca) Method, Faujia Islam

Graduate Theses, Dissertations, and Problem Reports

As sustainability has emerged as a highlight for almost every field over the last few decades, the manufacturing field is no exception. Generally, additive manufacturing performs better than traditional manufacturing in terms of sustainability because of its lean energy- and material usage. Previous studies have compared the sustainability performance between traditional and additive manufacturing, but hybrid manufacturing was not focused upon much. In this paper, the life cycle assessment method is used to analyze and compare the energy consumption and environmental impact of direct energy deposition (DED) based hybrid manufacturing and traditional manufacturing “CNC milling” process for a turbine blade. …