Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Environmental Engineering

PDF

Marquette University

Bio-oil

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Anaerobic Co-Digestion Of Aqueous Liquid From Biosolids Pyrolysis, Seyedfatemeh Seyedi Apr 2018

Anaerobic Co-Digestion Of Aqueous Liquid From Biosolids Pyrolysis, Seyedfatemeh Seyedi

Master's Theses (2009 -)

Pyrolysis is a process to treat biosolids and recover energy. During pyrolysis, conversion of organic matter to energy-rich products yields biochar, py-gas, and pyrolysis liquids (aqueous phase and non-aqueous bio-oil). The aqueous pyrolysis liquid (APL), is a high-COD liquid with no apparent use that contains polycyclic aromatic hydrocarbons and nitrogen-containing compounds. One potential beneficial use of APL is as a co-digestate to produce more biogas for renewable energy from anaerobic digesters at municipal water resource recovery facilities. Some of the organics in APL may be converted to biomethane via anaerobic digestion under proper conditions. However, some APL organics are known …


Pyrolysis Of Dried Wastewater Biosolids Can Be Energy Positive, Patrick J. Mcnamara, Jon Koch, Zhongzhe Liu, Daniel Zitomer Sep 2016

Pyrolysis Of Dried Wastewater Biosolids Can Be Energy Positive, Patrick J. Mcnamara, Jon Koch, Zhongzhe Liu, Daniel Zitomer

Civil and Environmental Engineering Faculty Research and Publications

Pyrolysis is a thermal process that converts biosolids into biochar (a soil amendment), py-oil and py-gas, which can be energy sources. The objectives of this research were to determine the product yield of dried biosolids during pyrolysis and the energy requirements of pyrolysis. Bench-scale experiments revealed that temperature increases up to 500 °C substantially decreased the fraction of biochar and increased the fraction of py-oil. Py-gas yield increased above 500 °C. The energy required for pyrolysis was approximately 5-fold less than the energy required to dry biosolids (depending on biosolids moisture content), indicating that, if a utility already uses energy …