Engineering Commons^™

Naio4 Oxidation Of Mussel Adhesive Protein Film And Its Corrosion Protection For Mg-1.0ca Alloy, Rui-Qing Hou, Ping-Li Jiang, Shi-Gang Dong, Chang-Jian Lin

Journal of Electrochemistry

The effect of oxidation of mussel adhesive protein (Mefp-1) film on the corrosive resistance for Mg-1.0Ca alloy was investigated by scanning electron microscopy (SEM), atom force microscopy (AFM), electron probe microanalysis (EPMA), Infrared reflection absorption spectroscopy (IRAS) and electrochemical methods. The results showed that the NaIO₄ induced oxidation of the pre-formed Mefp-1 film with porous morphology involved structural change of the DOPA group in the protein and resulted in a more uniform film with net-like morphology. The protein film without oxidation had an increasing resistance for the corrosion of Mg-1.0Ca alloy up to 7 days exposure. After oxidation, Epit …

Thermal Shock Studies On Carbon-Carbon Composites: Experimentation And Analysis, Alma Lucia Leanos

Open Access Theses & Dissertations

The oxidation behavior of C/C composites under thermal shock conditions in air is understood and predicted experimentally and by computational efforts. In Chapter. 1, both compressive properties and oxidation behavior of pristine and thermal shock exposed 2D C/C composite specimens were examined. Pristine test specimens were exposed to thermal shock conditions with temperatures ranging from 400°C to 1000°C in an oxidizing environment, followed by compression tests on pristine and thermal shock exposed specimens to obtain their compressive responses.

Similarly, in Chapter. 2, the influence of thermal shock conditions on both, the extent of carbon materials decomposition and the through-thickness compressive …

Aero-Thermal Characterization Of Silicon Carbide Flexible Tps Using A 30kw Icp Torch, Walten Owens

Graduate College Dissertations and Theses

Flexible thermal protection systems are of interest due to their necessity for the success of future atmospheric entry vehicles. Current non-ablative flexible designs incorporate a two-dimensional woven fabric on the leading surface of the vehicle. The focus of this research investigation was to characterize the aerothermal performance of silicon carbide fabric using the 30 kW Inductively Coupled Plasma Torch located at the University of Vermont. Experimental results have shown that SiC fabric test coupons achieving surface temperatures between 1000°C and 1500°C formed an amorphous silicon dioxide layer within seconds after insertion into air plasmas. The transient morphological changes that occurred …

High Temperature Oxidation Of Nb-Cr-Mo-Si-B Alloys, Kathryn S. Thomas

Open Access Theses & Dissertations

It has been the trend to use nickel based superalloys in high temperature applications, however higher temperatures are required in the effort to enhance the efficiency of such components as jet turbine engines. The melting temperature of the nickel based superalloy limits the extent to which temperature can be raised as these materials are typically used at temperatures within 200 degrees of their melting point. Refractory metal based systems are attractive due to their high melting points, low densities, and good high temperature strength. However, in such cases as niobium, poor oxidation resistance limits the widespread use of such alloys. …