Engineering Commons^™

Evaluating Electrification Of Fossil Fuel-Fired Boilers For Decarbonization Using Discrete Event Simulation, Nahian Ismail Chowdhury

Graduate Theses, Dissertations, and Problem Reports

Decarbonizing fossil fuel usage is crucial in mitigating the impacts of climate change. CO2, which comprises the major portion of greenhouse gas, is emitted from burning fossil fuels. One of the significant sources of fossil fuel user is industrial process heating, and most of the heating in industrial processes is achieved through boilers. Electrification is a promising solution for decarbonizing these boilers, as it enables renewable energy sources to generate electricity, which can then be used to power the electric boilers. The electrification of boilers can reduce greenhouse gas emissions, improve air quality, and increase energy efficiency. However, it requires …

Computational Study On Suppression Of Airfoil Flow Separation Using High-Frequency Translational Surface Actuation, Bibek Gupta

Honors Theses

Flow separation is a phenomenon that occurs when pressure increases in the streamwise direction of a flow, making a distinctive boundary layer or separation bubble. It causes aircraft to experience an increase in drag and noise and a decrease in a lift, hence degrading their aviation performance. This study uses numerical simulations to understand better the effects of high-frequency translational surface actuation (HFTSA) on flow separation control. The numerical simulations mimic the experimental parameters of an experiment performed by Okoye et al. on using the HFTSA system to control flow separation. A symmetrical airfoil structure of chord length of 0.3 …

A Framework For Energy Optimization Of Small, Two-Stroke, Natural Gas Engines For Combined Heat And Power Applications, Mahdi Darzi

Graduate Theses, Dissertations, and Problem Reports

This research was focused on the development of a framework for the energy optimization a natural gas engine for small combined heat and power (CHP) applications operating with low-pressure natural gas (NG) available at homes. The required targets of the ARPA-E GENSETS program for 1 kW electric power generation and previous GENSETS simulation at West Virginia University, suggested a design space for the engine which is currently dominated by simple two-stroke designs. Hence this research focused on screening, modeling, and experimentally evaluation of cost-effective technologies to achieve a system design that maximized thermal efficiency and utilization factor, while reducing emissions. …

Energy Models Of The Txaire Houses, Tajudeen Amadu Annafi

Mechanical Engineering Theses

Model calibration is important as its functions improve building models. A calibrated model of the TxAIRE Houses #1 and #2 have been developed using the OpenStudio software. The model was developed and calibrated with data of the year 2014 but can be used predict electricity consumption of any year.

An actual meteorological year (AMY) weather file was also created for the houses which was used for calibration. The data used to develop this weather file were measured on-site which improved the accuracy of the model. It was found that an error difference of -1.0 % and -4.2 % occurred between …

Simulation Of An Intake Manifold Pre-Heater For Cold Diesel Engine Startup, Patrick K. Kreun

Masters Theses

Ensuring consistent, reliable diesel engine startups in cold temperatures is of utmost importance in a number of applications. Under extreme temperatures, the use of glow plugs is complemented by intake manifold heaters. In these, the energy released from combustion increases the intake air temperature before the air enters the main combustion chamber. Since the process also alters the stoichiometry of the fuel-air mixture at the intake ports, the preheater operation must be optimized in order to guarantee successful and reliable in-cylinder combustion during engine startups. This paper describes the development of an intake manifold model incorporating an air pre-heater for …

Development Of Cfd Models For The Purposes Of Exploring Free Surface Wave Phenomena, Leonard P. Stoehr

Masters Theses

With the push for finding alternative, green energy sources, the harnessing of energy from ocean and lake waves is becoming a more researched field. To fully understand the behavior of wave interactions and optimize designs to extract this energy, it is necessary to develop computer models that can accurately replicate this behavior. A case is presented in which previous work done using the wave tank found in the Western Michigan University fluids lab is examined. The case involves harnessing the energy generated by ocean waves through the usage of plates of different shapes resting horizontally on the water’s surface. The …