Engineering Commons^™

Final Design Report: Grasp Data Acquisition Project Axon Vr, Michael Erberich, Jack Schultz, Tyler Yeaman

Mechanical Engineering

No abstract provided.

Final Design Report: Allergen Mixing Assistant (Ama) Micro-Refrigeration Redesigning, Mitchell Parks, Minwoo (Michael) Suh

Mechanical Engineering

Abstract

Allergen Mixing Assistant (AMA) by Xtract Solutions is a device designed to more “effectively refrigerate, organize, and mix allergenic extracts”. Although Xtract Solutions intended the product to be fully automated, the company has decided against its automation and declared its current design as a minimum viable product whose components are too expensive, difficult to source and complex. Therefore, Cal Poly AMA design team - Mitchell Parks and Minwoo Suh - has decided to replace these expensive components with much more economical alternatives as shown below:

Stirling cooler

→

Thermoelectric (Peltier) cooler

Custom Arduino

Controller Card

→

TEC Thermostat *** …

Cp Ev Dynamics, Steven Montevideo, Ashlie Reott, L. Carter Price

Mechanical Engineering

No abstract provided.

Biomimetic Seal Flipper Test Rig, Gordon D. Belyea, Laura Kawashiri, Dylan Rinker, Kurt Beske

Mechanical Engineering

No abstract provided.

Automated Bearing Press, David Baker, David Brock, Engelbert Diec

Mechanical Engineering

Our group was presented with a challenge to design an automated machine to replace Micro-Vu’s current manual pressing operation. We moved, planned, and scheduled our tasks for the three quarters we will be working on this project by using a Gantt chart. In designing the machine, we generated concepts and used analysis and prototyping to select the most promising ones. Our final design uses a pneumatic press to press the parts, and it includes magazines to hold the parts before pressing, pneumatic actuators to move the parts to and from the pressing location, and a lever to separate the defective …

Magnetic Bearing For Bently Nevada Rk4 Rotor Kits, Sean Fowler, Garrett Olson

Mechanical Engineering

Active Magnetic Bearings (AMB) are contact free bearings that support loads by magnetic levitation. This is accomplished by generating magnetic forces with electric current through a series of electromagnets surrounding a suspended rotor mass. Along with a set of electromagnets, an AMB assembly also consists of power amplifiers for each electromagnet, a controller, and proximity sensors. The proximity sensors provide rotor position feedback to the control system, which modulates power to the amplifiers [4]. Magnetic bearings are used in several industrial applications today, including but not limited to compressors, turbines, pumps, motors, and generators. Advantages of their utility include very …

Low Cost Metal Chip Separator, Alek Linquist, Kale Mckinney, Ryan Jones

Mechanical Engineering

We were tasked by Micro-Vu to design, build, and test a small-scale low-cost metal chip separator to operate on one of their 24/7 mills. The goal of the project was to separate the steel and aluminum chips coming off of the mill’s chip conveyor to end up with a bin of 99% pure aluminum by mass. To accomplish this goal we first brainstormed various possible ideas and performed small scale tests the best ones. After further review we determined the best solution to this problem was a design that involved a cycling magnetic backing that would pull steel out of …

Electric Vehicle Torque Vectoring And Rear Steering Control System, Garrett Heinen, Vincent Lee, Michael Parker, Michael Saggese

Mechanical Engineering

NDA