Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Engineering
Development Of A Low-Cost, Photovoltaic-Powered, Automated Water Recovery System, David E. Daley
Development Of A Low-Cost, Photovoltaic-Powered, Automated Water Recovery System, David E. Daley
Master's Theses
An existing water filtration system at the Channel Islands Marine & Wildlife Institute (CIMWI) wastes approximately 25 gallons of water per day rinsing out solid waste under light load. To reduce CIMWI’s water and energy consumption, an automated system was designed and built to recover the rinse water and return it to the existing filtration loop. Models for fluid system requirements, basic energy needs, and photo- voltaic energy generation were created to aid in component selection. Basic sensors and electronics were programmed in Python for use with a Raspberry Pi single board computer to collect and process water recovery data …
Modeling And Control Of A Vertical Hopping Robot, Bradley Y. Kwan
Modeling And Control Of A Vertical Hopping Robot, Bradley Y. Kwan
Master's Theses
Single degree-of-freedom hopping robots are typically modeled as spring loaded inverted pendulums (SLIPs). This simplified model, however, does not consider the overall leg geometry, consequently making it difficult to investigate the optimized inertial distribution of the leg for agile locomotion. To address this issue, the first part of this thesis establishes an accurate mathematical model of a DC-motor-driven, two-link hopping robot where the motors are modeled as torque sources. The equations of motion for the two distinct phases of locomotion (stance and flight) are derived using the Lagrangian approach for holonomic systems. A Simulink/Stateflow model is developed to numerically simulate …