Engineering Commons^™

Analysis And Development Of Multiple Phase Shift Modulation In A Sic-Based Dual Active Bridge Converter, Yu Yan

Doctoral Dissertations

Renewable energy adoption is a popular topic to release the stress of climate change caused by greenhouse gas. Electricity is ideal secondary energy for clean primary energy such as nuclear, wind, photovoltaic, and so on. To extend the application of electricity and reduce fossil energy consumption by transportation sectors, electric vehicles (EVs) become promising technology that can further inspire the development of renewable energy.

Battery as the core in an EV provides the energy to the motor and all on-board electric equipment. The battery charger is mainly composed of a power factor correction (PFC) and isolated DC-DC converter. Therefore, power …

Power Quality Control And Common-Mode Noise Mitigation For Inverters In Electric Vehicles, Yang Huang

Doctoral Dissertations

Inverters are widely utilized in electric vehicle (EV) applications as a major voltage/current source for onboard battery chargers (OBC) and motor drive systems. The inverter performance is critical to the efficiency of EV system energy conversion and electronics system electro-magnetic interference (EMI) design. However, for AC systems, the bandwidth requirement is usually low compared with DC systems, and the control impact on the inverter differential-mode (DM) and common-mode (CM) performance are not well investigated. With the wide-band gap (WBG) device era, the switching capability of power electronics devices drastically improved. The DM/CM impact that was brought by the WBG device-based …

Stability Analysis And Design Of Grid-Interactive Power Electronic Converters, Le Kong

Doctoral Dissertations

The increasing penetration of power electronic converters (PECs) can provide high flexibility, full controllability, sustainability, and improved efficiency for future electric power systems. However, it also introduces new challenges since the wide-frequency-band control dynamics of PECs can interact with the power system and result in different types of instability issues. To holistically address the instability issues, several research activities are conducted in this dissertation.

The modular multilevel converter (MMC), which is one of the most common PECs in high- or medium-voltage power systems, is investigated. An improved MMC dc impedance model is developed by considering both the submodule voltage and …

Load Modeling And Evaluation Of Leds For Hardware Test Bed Application, Jillian M. Ruff

Masters Theses

The lighting industry was revolutionized with the emergence of LED lighting. Over the last 15 years, LED lighting device sales and utilization have grown immensely. The growth and popularity of LEDs is due to improved operation of the device when compared to previous lighting technologies. Efficient performance of the device is critical due to the growth of global energy consumption.

As nonrenewable generation fuel is finite, utilities have begun the transition to renewable energy generation. Generation and distribution systems become inherently complex to comprehend and maintain with incorporation of emerging supply and load technologies. With the unprecedented growth of LED …

A Bulk Driven Transimpedance Cmos Amplifier For Sipm Based Detection, Shahram Hatefi Hesari

Masters Theses

The contribution of this work lies in the development of a bulk driven operational
transconducctance amplifier which can be integrated with other analog circuits and
photodetectors in the same chip for compactness, miniaturization and reducing the
power. Silicon photomultipliers, also known as SiPMs, when coupled with scintillator materials are used in many imaging applications including nuclear detection. This thesis discuss the design of a bulk-driven transimpedance amplifier suitable for detectors where the front end is a SiPM. The amplifier was design and fabricated in a standard standard CMOS process and is suitable for integration with CMOS based SiPMs and commercially …

Systematic Design Of A 100 W 6.78 Mhz Wireless Charging Station Covering Multiple Devices And A Large Charging Area, Jie Li

Doctoral Dissertations

Wireless power transfer (WPT) promises to offer safe and convenient charging in consumer electronics applications. The application ranges from sub-watt medical implant device charging to watt-level household charging, further to the kilowatt electric vehicle (EV) and railway charging. At present, two industry standards are widely used to guide the WPT product design. The Qi standard describes an application that requires the receiver to be placed close to the transmitter, called "tightly coupled" WPT. The receiver coil typically has a similar size compared to the transmitter. And the operation frequency is in the kHz range. The Airfuel standard, on the other …

A Ringamp-Assisted, Output Capacitor-Less Analog Cmos Low-Dropout Voltage Regulator, Jordan Sangid

Doctoral Dissertations

Continued advancements in state-of-the-art integrated circuits have furthered trends toward higher computational performance and increased functionality within smaller circuit area footprints, all while improving power efficiencies to meet the demands of mobile and battery-powered applications. A significant portion of these advancements have been enabled by continued scaling of CMOS technology into smaller process node sizes, facilitating faster digital systems and power optimized computation. However, this scaling has degraded classic analog amplifying circuit structures with reduced voltage headroom and lower device output resistance; and thus, lower available intrinsic gain. This work investigates these trends and their impact for fine-grain Low-Dropout (LDO) …

Data Center Power System Emulation And Gan-Based High-Efficiency Rectifier With Reactive Power Regulation, Jingjing Sun

Doctoral Dissertations

Data centers are indispensable for today's computing and networking society, which has a considerable power consumption and significant impact on power system. Meanwhile, the average energy usage efficiency of data centers is still not high, leading to significant power loss and system cost.

In this dissertation, effective methods are proposed to investigate the data center load characteristics, improve data center power usage efficiency, and reduce the system cost.

First, a dynamic power model of a typical data center ac power system is proposed, which is complete and able to predict the data center's dynamic performance. Also, a converter-based data center …

A High Frequency Wireless Power Transfer System For Electric Vehicle Charging Using Multi-Layer Non-Uniform Self-Resonant Coil, Ruiyang Qin

Doctoral Dissertations

Wireless EV (Electric Vehicle) charging is an emerging technology with rapid development in the past decade. Compared to wired EV chargers, wireless power transfer (WPT) enables safe and unobtrusive charging for EVs.

This work proposes high frequency wireless charging using a self-resonant (SR) coil at several megahertz. A multi-layer self-resonant coil structure is proposed, allowing high quality factor coils to be fabricated from layers of inexpensive copper foil and dielectric film. Additionally, the self-resonant coil utilizes its interlayer capacitance for resonance, eliminating the external compensation capacitor and shrinking the overall volume of passive component to increase the power density. Comparing …

Development Of Arduino-Based Portable Systems For Electroanalytical Detection, Jiamei Huang

Masters Theses

This work presents the development of a multi-mode electroanalytical detection system based on Arduino microcontroller board. First, a multichannel impedance readout system is designed for alternating current electrokinetics (ACEK) based capacitive sensing. ACEK phenomena on 100μm interdigitated electrodes are observed via fluorescent particles as well as bioparticles, which illustrate the mechanisms of ACEK target enrichment for the capacitive sensing method. I2C multiplexer is applied to allow multiple impedance converters to work together providing continuous AC signals for ACEK capacitive sensing. Second, an electronic nose composed of three modules including a gas sensor array, a circuit for signal acquisition integrated with …

The Bracelet: An American Sign Language (Asl) Interpreting Wearable Device, Samuel Aba, Ahmadre Darrisaw, Pei Lin, Thomas Leonard

Chancellor’s Honors Program Projects

No abstract provided.

Design And Evaluation Of A Unique Weighted-Sum-Based Anger Camera, Matthew W. Seals

Masters Theses

Anger camera imaging technology has become widely popular for neutron diffraction imaging due to recent shortages in Helium-3 (He-3). Research into neutron diffraction optimized Anger camera by the Oak Ridge National Laboratory (ORNL) detectors group has provided an alternative to He-3 Tube-based detectors with a high-resolution Anger camera. However, the cost of these high-resolution Anger camera technology can make it less attractive than He-3 tubes when a large Field of View (FOV) is desired. Currently, there is a need for a lower-cost alternative to this high-resolution anger camera. Further applications for Anger camera have become of interest with the advent …