Engineering Commons^™

Cyber-Threat Detection Strategies Governed By An Observer And A Neural-Network For An Autonomous Electric Vehicle, Douglas Scruggs

All Theses

A pathway to prevalence for autonomous electrified transportation is reliant upon accurate and reliable information in the vehicle’s sensor data. This thesis provides insight as to the effective cyber-attack placements on an autonomous electric vehicle’s lateral stability control system (LSCS). Here, Data Integrity Attacks, Replay Attacks, and Denial-of-Service attacks are placed on the sensor data describing the vehicle’s actual yaw-rate and sideslip angle. In this study, there are three different forms of detection methods. These detection methods utilize a residual metric that incorporate sensor data, a state-space observer, and a Neural-Network. The vehicle at hand is a four-motor drive autonomous …

The Application Of Model Predictive Control On Paralleled Converters For Zero Sequence Current Suppression And Active Thermal Management, Justin Dobey

All Theses

In the field of power electronics, the control of rectifiers is a crucial area of study. Rectifiers are used to convert AC power into DC power, and are commonly used in a wide range of applications, including renewable energy systems, industrial automation, and consumer electronics. However, in medium and high-power systems when multiple rectifiers are connected in parallel to a DC bus, stability issues can arise, including voltage fluctuations, zero sequence circulating current, and thermal imbalance.

Achieving stable DC bus voltage is essential for maintaining the proper functioning of electronic devices, while suppressing zero sequence current is necessary for protecting …

Virtual Prototyping Of Pebb Based Power Electronics System For Ground Vehicles, Yi Li

All Theses

Power electronics are heavily involved in power and energy systems in plenty of applications nowadays. The increase of demand brings more challenges into simulations for development. Considering the complexity of the systems and high frequency operational conditions, this paper presents comprehensive research on modeling, simulating, and validation on ground vehicle propulsion system applications.

To reduce the computational burden, the Power Electronics Building Blocks concept is utilized to simplify the structure of modeling under different conversion scenarios in ground vehicle systems. In addition, the Average and Switching versions models are included. To speedup the simulation, the engagement of advanced computing technique …

Investigation Of Vo2 Thin Films And Devices For Opto-Electromechanical Applications, Samee Azad

All Dissertations

Specialized and optimized low pressure direct oxidation technique have been implemented to synthesize high quality VO₂ thin films on various substrates (sapphire, SiO₂/Si, AT-cut quartz, GaN/AlGaN/GaN/Si and muscovite). Structural and surface characterization methods such as X-ray diffraction, Raman spectroscopy and atomic force microscopy have been administered on the grown VO₂ films which indicate their material quality. Transition of characteristics of the VO₂ films are caused by semiconductor metal transition (SMT). This phenomenon is attributed as the change maker in transition of resistivity and transmitted optical power through the VO₂ films. Apart the substrates mentioned, …

Universal Short-Circuit And Open-Circuit Fault Detection For An Inverter, Buck Brown

All Theses

Short-circuit and open-circuit faults of an inverter’s power device often lead to catastrophic failure of the entire system if not detected and acted upon within a few microseconds, particularly for emerging wide bandgap (WGB) power semiconductors. While a significant amount of research has been done on the fast and accurate protection and detection of short-circuit faults, there has been less success corresponding to the research on open-circuit faults. Common downfalls include protection and detection that are too application-specific, take longer than a couple of microseconds, and are not cost-efficient. This study proposes a new open-circuit fault protection and detection system …

Design And Implementation Of High-Efficiency, Lightweight, System-Friendly Solid-State Circuit Breaker, Dehao Qin

All Dissertations

Direct current (DC) distribution system has shown potential over the alternative current (AC) distribution system in some application scenarios, e.g., electrified transportation, renewable energy, data center, etc. Because of the fast response speed, DC solid-state circuit breaker (SSCB) becomes a promising technology for the future power electronics intensive DC energy system with fault-tolerant capability. First, a thorough literature survey is performed to review the DC-SSCB technology. The key components for DC-SSCB, including power semiconductors, topologies, energy absorption units, and fault detection circuits, are studied. It is observed that the prior studies mainly focus on the basic interruption capability of the …

Photovoltaics, Batteries, And Silicon Carbide Power Electronics Based Infrastructure For Sustainable Power Networks, Prahaladh Paniyil

All Dissertations

The consequences of climate change have emphasized the need for a power network that is centered around clean, green, and renewable sources of energy. Currently, Photovoltaics (PV) and wind turbines are the only two modes of technology that can convert renewable energy of the sun and wind respectively into large-scale power for the electricity network. This dissertation aims at providing a novel solution to implement these sources of power (majorly PV) coupled with Lithium-ion battery storage in an efficient and sustainable approach. Such a power network can enable efficiency, reliability, low-cost, and sustainability with minimum impact to the environment.

The …

Assessing Hardware Security Threats Posed By Hardware Trojans In Power Electronics, Quinn Kinzie

All Theses

This study investigates the threat of hardware Trojans (HTs) in power electronics applications, a rising concern due to the growing demand for cost-effective embedded solutions in power systems. With the supply chain for electronic hardware devices expanding globally, particularly to low-cost foundries in foreign locations, there is an increasing risk of HT attacks. While there has been extensive research on HTs in computer applications, little consideration has been given to their threat in power electronics. This study demonstrates the effectiveness of a power electronics HT by implementing a novel HT design into a gate drive circuit. Additionally, the research proposes …