Evaluation Of Single Phase Smart Pv Inverter Functions In Unbalanced Residential Distribution Systems, Darren Symonette

Graduate Theses and Dissertations

In the United States, smart PV inverters integrated with residential distribution systems are becoming a more common occurrence. With integration of smart PV inverters, power utilities are experiencing an increase of number of operations with regards to switched capacitor banks, voltage regulators and on load tap changers. These increases can lead to excess wear and tear on the devices causing power utilities to perform unwanted replacement and maintenance. However, smart PV inverters when controlled under specific functions can enable these inverters to provide reactive power and voltage control which in turn lowers the number of operations for switched capacitor banks, …

Model Predictive Control For Grid Scale Pv And Battery, Sahithi Chatradi

Theses and Dissertations

Model Predictive Control (MPC) is a control technique that uses prediction data to optimize costs over a given predictive horizon. There are many papers that use this technique to optimize cost in a substantially loaded microgrid, but these techniques are not feasible for utility-scale PV+Storage facility. In this study, MPC is used to optimize the cost for a utility-scale PV+Storage facility, by adding a factor of a possible curtailment. The thesis also presents the various factors that the MPC has in that utility size grid. These factors include line losses, net yield, and curtailment.

Robust Control Strategies For Optimal Operation Of Distributed Generation In Smart Microgrids, Chi-Thang Phan-Tan

Theses

The high penetration of PV systems and fast communications networks increase the potential for PV inverters to support the stability and performance of smart grids and microgrids. PV inverters in the distribution network can work cooperatively and follow centralized and decentralized control commands to optimize energy production while meeting grid code requirements. However, there are older autonomous inverters that have already been installed and will operate in the same network as smart controllable ones. This research proposes a decentralized optimal control (DOC) that performs multi-objective optimization for a group of PV inverters in a network of existing residential loads and …

The Hybridization Of A Graphene And Silicon Carbide Schottky Optoelectronic Device By The Incorporation Of A Lead Sulfide Quantum Dot Film, Joshua Letton

Theses and Dissertations

The work that follows examines the impact of lead sulfide quantum dots on a native epitaxial graphene (EG) SiC Schottky device, resulting in a hybrid optoelectronic device which presents a possible avenue towards a novel hybrid carbide-based Schottky solar cell. The active (n-type SiC) and contact (graphene) layers for the Schottky junction of the device were grown epitaxially using a novel technique incorporating tetrafluorosilane (TFS) as a precursor gas. The bare EG/SiC device was characterized based on its I-V behavior in dark and under illumination for both forward and reverse bias conditions. The initial characterization demonstrated the expected Schottky diode …

Neca Ghana Project, Michael T. Klee

Construction Management

Cal Poly’s motto is, “Learn by Doing" and for Cal Poly’s NECA Chapter, this isn’t simply a motto, but a directive for proactive change. For my senior project I will be leading the Cal Poly NECA chapter in the design, pre- fabrication and construction of a 5-7kw solar array, community center, ice production room and technology room in the remote fishing village of Agbokpa, Ghana. The solar array will power multiple industrial DC freezers, high efficiency LED lighting and charging stations while additionally powering water filtration and irrigation systems. Like many other fishing villages around the world, Agbokpa has no …

Transformerless High-Power Medium-Voltage Multi-Module Pv Converters, Hasan Bayat

Electronic Thesis and Dissertation Repository

This thesis is focused on the modular multilevel converter (MMC) for Photovoltaic (PV) applications. It is an attempt to address the issues associated with the modeling, control, and power mismatch elimination of the MMC-based PV systems. Firstly, a new real power reference generation scheme is proposed that creates a linear relationship between the real power reference of the system and the dc link voltage of the submodules. Further, a new power mismatch elimination strategy is proposed for the MMC-based PV system which ensures balanced currents are delivered to the host grid regardless of leg and arm power mismatches. The thesis …

Design And Optimization Of Hybrid Energy Storage For Photovoltaicpower Fluctuation Smoothing Based On Frequency Analysis, Yanting Zeng

Theses and Dissertations

As the output power of photovoltaic generation system is affected by factors such as light intensity and temperature, it creates greater randomness and volatility. When the power changes quickly and fluctuates, the traditional energy storage devices often can’t balance the power effectively. In this research Fast Fourier Transform (FFT) method is used to transform the photovoltaic stabilization power in the original time domain to the frequency domain for analysis. And percentage method was used to select the most typical PV data in the frequency domain. Then, the selected power was converted back to the time domain using Inverse Fast Fourier …

Design & Evaluation Of A Hybrid Switched Capacitor Circuit With Wide-Bandgap Devices For Dc Grid Applications, Joshua L. Stewart

Electrical and Computer Engineering ETDs

ABSTRACT

As technologies advance, the rate at which renewable power sources, such as solar photovoltaic (PV) and wind, are being added to the power grid is increasing. Typically, PV power plants require large inverters for direct current to alternating current (DC-AC) power conversion, as well as large transformers to step up voltages to the grid voltage. Offshore wind farms and large PV power plants in remote locations often aggregate power on a DC bus in order to improve efficiency and reduce the cost of power conversion hardware within the energy complex. However, the power must still be converted to AC …

Effective Pv Output Fluctuation Smoothing Based On Frequency Analysis And Different Weather Patterns, Kuei Hsu Kuo

Theses and Dissertations

As the Hybrid Energy Storage System (HESS) has the advantages of both power-based and energy-based energy storage devices. It is suitable for a microgrid to smooth the power fluctuation. Analyze the power data of a grid-connected photovoltaic (PV) power station. This research considers grid-connected PV requirements to join the HESS and take advantage of the HESS charge and discharge characteristics to reduce the problems caused by light intensity and temperature change of grid-connected PV power output fluctuations. Using battery optimization control strategies to reduce power and capacity of the HESS configuration. This paper Analyze the effect evaluation when HESS rated …

Simulation, Measurement, And Emulation Of Photovoltaic Modules Using High Frequency And High Power Density Power Electronic Circuits, Yunas Erkaya

Electrical & Computer Engineering Theses & Dissertations

The number of solar photovoltaic (PV) installations is growing exponentially, and to improve the energy yield and the efficiency of PV systems, it is necessary to have correct methods for simulation, measurement, and emulation. PV systems can be simulated using PV models for different configurations and technologies of PV modules. Additionally, different environmental conditions of solar irradiance, temperature, and partial shading can be incorporated in the model to accurately simulate PV systems for any given condition.

The electrical measurement of PV systems both prior to and after making electrical connections is important for attaining high efficiency and reliability. Measuring PV …

Optical Properties Of Solar Cells Based On Zinc(Hydr)Oxide And Its Composite With Graphite Oxide Sensitized By Quantum Dots, S. M. Zakirul Islam

Dissertations, Theses, and Capstone Projects

This thesis research focuses on developing a hybrid form of solar cell based on zinc(hydr)oxide and its composites with graphite oxide, TiO2, quantum dot, electrolyte and . This work expands upon the Gratzel solar cell with a dye in TiO2.

Due to various structural and optical characteristics, zinc(hydr)oxide (Zn(OH)2) and its porous composites with 2% and 5% graphite oxide(GO) can be used for various applications including the manufacture of various , protective elements in electric and electronic appliances, as gas-sensors, catalysts, in cosmetics a UV light absorber, and solar cells.

In this research, both TiO2 and zinc(hydr)oxide (refer as Zn(OH)2 …

Time Domain Simulation Of Novel Photovoltaic Materials, Haejun Chung

Open Access Theses

Thin-film silicon-based solar cells have operated far from the Shockley- Queisser limit in all experiments to date. Novel light-trapping structures, however, may help address this limitation. Finite-difference time domain simulation methods offer the potential to accurately determine the light-trapping potential of arbitrary dielectric structures, but suffer from materials modeling problems. In this thesis, existing dispersion models for novel photovoltaic materials will be reviewed, and a novel dispersion model, known as the quadratic complex rational function (QCRF), will be proposed. It has the advantage of accurately fitting experimental semiconductor dielectric values over a wide bandwidth in a numerically stable fashion. Applying …

Photovoltaic Emulator Adaptable To Irradiance, Temperature And Panel Specific I-V Curves, Joseph Gamos Durago

Master's Theses

This thesis analyzes the design and performance of a photovoltaic (PV) emulator. With increasing interest in renewable energies, large amounts of money and effort are being put into research and development for photovoltaic systems. The larger interest in PV systems has increased demand for appropriate equipment with which to test PV systems.

A photovoltaic emulator is a power supply with similar current and voltage characteristics as a PV panel. This work uses an existing power supply which is manipulated via Labview to emulate a photovoltaic panel. The emulator calculates a current-voltage (I-V) curve based on the user specified parameters of …

Preparation And Characterization Of Cigss Solar Cells And Pv Module Data Analysis, Jyoti Shirolikar

Electronic Theses and Dissertations

In this thesis, multiple activities have been carried out in order to improve the process of CIGSS solar cell fabrication on a 4" x 4" substrate. The process of CIGSS solar cell fabrication at FSEC's PV Materials Lab involves a series of steps that were all carried out manually in the past. A LABVIEW program has been written to carry out automated sputter deposition of Mo back contact, CuGa, In metallic precursors on a soda lime glass substrate using a stepper motor control for better uniformity. Further, selenization/ sulfurization of these precursors was carried out using rapid thermal processing (RTP). …

Fpga-Based Design Of A Maximum-Power-Point Tracking System For Space A, Todd Persen

Electronic Theses and Dissertations

Satellites need a source of power throughout their missions to help them remain operational for several years. The power supplies of these satellites, provided primarily by solar arrays, must have high efficiencies and low weights in order to meet stringent design constraints. Power conversion from these arrays is required to provide robust and reliable conversion which performs optimally in varying conditions of peak power, solar flux, and occlusion conditions. Since the role of these arrays is to deliver power, one of the principle factors in achieving maximum power output from an array is tracking and holding its maximum-power point. This …