Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 19 of 19
Full-Text Articles in Engineering
Characterization Of Quad-Copter Positioning Systems And The Effect Of Pose Uncertainties On Field Probe Measurements, James C. Dossett
Characterization Of Quad-Copter Positioning Systems And The Effect Of Pose Uncertainties On Field Probe Measurements, James C. Dossett
Theses and Dissertations
When measuring the Radar Cross Section (RCS) of a test object, many uncertainties must be accounted for, such as the non-homogeneous nature of the medium between the radar test equipment and the platform under test. There are a variety of other error sources, including clutter and Radio Frequency Interference (RFI), motivating the development of techniques to measure and model the uncertainties in RCS measurements. The following research, in unison with prior and current efforts, intends to reduce the impact of these uncertainties by utilizing a unique two-way field probe in the form of a geodesic sphere encompassing a commercial quad-copter …
Utilization Of A Geodesic Sphere And Quadcopter As Two-Way Field Probe For Electro-Magnetic Field Measurements In An Indoor Radar Cross Section Range, Nathan Lett
Theses and Dissertations
Radar Cross Section (RCS) measurements rely heavily on multiple assumptions. Uncertainty in the final measurement is determined based on these assumptions. One source in particular is the non-homogeneous nature of the transmission path between radar test equipment and a target under test. The following research extends prior research. This thesis intends to provide a unique two-way field probe solution for measuring Electro-magnetic (EM) fluctuations in a test volume. In this thesis, the design, development, and demonstration of a geodesic sphere encased quadcopter two-way probe is explained. The Parrot® Bebop Drone quadcopter was used with a 2v frequency divided geodesic sphere …
An Inquiry: Effectiveness Of The Complex Empirical Mode Decomposition Method, The Hilbert-Huang Transform, And The Fast-Fourier Transform For Analysis Of Dynamic Objects, Kristen L. Wallis
An Inquiry: Effectiveness Of The Complex Empirical Mode Decomposition Method, The Hilbert-Huang Transform, And The Fast-Fourier Transform For Analysis Of Dynamic Objects, Kristen L. Wallis
Theses and Dissertations
A review of current signal analysis tools show that new techniques are required for an enhanced fidelity or data integrity. Recently, the Hilbert-Huang transform (HHT) and its inherent property, the Empirical Mode Decomposition (EMD) technique, have been formerly investigated. The technique of Complex EMD (CEMD) was also explored. The scope of this work was to assess the CEMD technique as an innovative analysis tool. Subsequent to this, comparisons between applications of the Hilbert transform (HT) and the Fast-Fourier transform (FFT) were analyzed. MATLAB was implemented to model signal decomposition and the execution of mathematical transforms for generating results. The CEMD …
Frequency Diversity For Improving Synthetic Aperture Radar Imaging, Jawad L. Farooq
Frequency Diversity For Improving Synthetic Aperture Radar Imaging, Jawad L. Farooq
Theses and Dissertations
In this work, a novel theoretical framework is presented for using recent advances in frequency diversity arrays (FDAs). Unlike a conventional array, the FDA simultaneously transmits a unique frequency from each element in the array. As a result, special time and space properties of the radiation pattern are exploited to improve cross-range resolution. The idealized FDA radiation pattern is compared with and validated against a full-wave electromagnetic solver, and it is shown that the conventional array is a special case of the FDA. A new signal model, based on the FDA, is used to simulate SAR imagery of ideal point …
Application Of Time-Frequency Representation To Non-Stationary Radar Cross Section, John D. Mcshane
Application Of Time-Frequency Representation To Non-Stationary Radar Cross Section, John D. Mcshane
Theses and Dissertations
Radar Cross Section (RCS) imaging of a non-wide sense stationary signal poses significant problems in identifying scattering centers in the post processed radar- generated image. A non-wide sense stationary RCS is typically encountered when moving parts on the target impress a phase shift into the backscatter signal that is uncorrelated to the previous return pulse. When the Fourier transform of the phase shifted complex signal is taken, range and cross range information on scattering centers are misplaced. Time Frequency Representations (TFR) must be used to help locate these scattering centers so they can be properly treated to reduce the target’s …
Investigation Of The Effects Of Target Feature Variations On Ballistic Missile Rcs, Sang H. Lee
Investigation Of The Effects Of Target Feature Variations On Ballistic Missile Rcs, Sang H. Lee
Theses and Dissertations
Uncertainties about certain features of target geometries can result in a loss of confidence in target signature assessment. This thesis describes the development of a general "rule-of-thumb" to determine how the radar signature of a target varies as a function of the target's specific features. The targets of interest in this study are fictitious ballistic missiles. Four target features of these missiles are investigated: fin size, nose cone shape, panel riveting along the sides of the missile, and heat shielding on the nose cone. By varying these target features in different missile configurations, and comparing them to each other, a …
Nonlinear Suppression Of Range-Ambiguous Clutter For Outdoor Radar Measurement Facilities, Michael C. Baumgartner
Nonlinear Suppression Of Range-Ambiguous Clutter For Outdoor Radar Measurement Facilities, Michael C. Baumgartner
Theses and Dissertations
In the outdoor measurement facility, a certain amount of real estate is owned by the organization, and therefore can be groomed to keep clutter contributions to a minimum. As the transmit signal travels further down range, however, returns from long-range clutter sources are inevitable and can have a significant impact on measurement accuracy. This research effort investigates the effectiveness of employing nonlinear suppression (NLS) to abate long-range ambiguous clutter in these facilities. Initial testing provides an extended proof-of-concept for coincident point scatterers representing target and clutter sources. The NLS process is finally applied to simulated measured data from the National …
Comparison Of Computational Electromagnetic Codes For Prediction Of Low-Frequency Radar Cross Section, Paul C. Lash
Comparison Of Computational Electromagnetic Codes For Prediction Of Low-Frequency Radar Cross Section, Paul C. Lash
Theses and Dissertations
Radar cross section (RCS) prediction of full-scale aircraft is of interest to military planners for a variety of applications. Several computational electromagnetic codes for RCS prediction are available with differing features and capabilities. The goal of this research is to compare the capabilities of three computational electromagnetic codes for use in production of RCS signature assessments at low frequencies in terms of performance, accuracy, and features: Fast Illinois Solver Code (FISC), Code for Analysis of Radiators on Lossy Surfaces (CARLOS-3D), and Science Applications International Corporation Full-wave solver (SAF). The comparison is accomplished through analysis of predicted and measured RCS of …
Characterization Of The Target-Mount Interaction In Radar Cross Section Measurement Calibrations, Donald W. Powers
Characterization Of The Target-Mount Interaction In Radar Cross Section Measurement Calibrations, Donald W. Powers
Theses and Dissertations
Radar Cross Section (RCS) measurements are quintessential in understanding target scattering phenomenon. The reduced RCS of modern weapons systems stresses the capability of current RCS measurement ranges. A limiting factor that has recently become more significant is the electromagnetic coupling between a test target and the mounting hardware used to support it and control its orientation during the RCS measurement. Equally important is the electromagnetic coupling between the RCS calibration artifact and its mount, which provides an opportunity to explore the coupling phenomena without delving into operationally sensitive areas. The primary research goal was to characterize the interaction between a …
Bistatic Radar Cross Section (Rcs) Characterization Of Complex Objects, Robert L. Eigel Jr.
Bistatic Radar Cross Section (Rcs) Characterization Of Complex Objects, Robert L. Eigel Jr.
Theses and Dissertations
This research addresses some phenomenological aspects of bistatic scattering from a complex object with an emphasis on specular, shadowing, dihedral, and cavity effects. Five targets are investigated for their simplicity and ability to highlight certain scattering phenomena. Direct measurements of scattered electromagnetic energy and simulation data is gathered for a frequency bandwidth of 6-18 GHz. Both ray tracing and scattering center approaches are used to describe the bistatic mechanisms. An appraisal of the effectiveness and utility of the monostatic-to-bistatic equivalence theorems (Kell's and Crispin's) and several commercial scattering prediction codes is also accomplished. Simulation data is generated from two different …
Radar Cross Section Enhancement Of Simple Targets, Brian J. Crothers
Radar Cross Section Enhancement Of Simple Targets, Brian J. Crothers
Theses and Dissertations
This thesis explores the use of periodic open slots as passive antenna scatterers to enhance the radar cross section of a simple target. Two slot geometries are considered, thin rectangular slots and circular slots. Targets are modified with slot arrays of various element size, spacings, numbers, and geometries. These geometries were later backed by a cavity in an attempt to further enhance RCS. Measurements were taken and the results were compared to target baselines, which are nothing more than the unslotted version of the same target. Moment method solutions were also computed for comparisons with measured results. Additionally, an analytical …
Scattering From Dielectric Bodies, Jeffery M. Parks
Scattering From Dielectric Bodies, Jeffery M. Parks
Theses and Dissertations
The purpose of this study was to develop an RCS measured database of non-PEC targets and provide an example of its use to validate a code, 3D-RCIE. RCS prediction codes that handle penetrable materials require measured data to determine their accuracy. The materials used for this research include polyethylene and polyurethane with dielectric constants around 2.3 and 1.03, respectively. The polyethylene targets include a mini-arrow, ogive, conesphere, conesphere with a gap, sphere, and a large and small cube. The cubes were the only targets made from the polyurethane foam. Additionally, r-card was applied to the cubes and mini-arrow. The material …
Using Cross-Eye Techniques To Counter Radio Frequency Agile Monopulse Processing, Gregory J. Meyer
Using Cross-Eye Techniques To Counter Radio Frequency Agile Monopulse Processing, Gregory J. Meyer
Theses and Dissertations
The purpose of this research was to evaluate how current cross-eye techniques protect an airborne platform versus a pulse-to-pulse Radio Frequency (RF) agile monopulse processing threat and, if necessary, develop a new cross-eye techniques to counter this threat. This research evaluates how both current retrodirective cross-eye techniques and an original technique, namely synchronized cross-eye, hide the true skin return in the time and frequency domain while preserving the necessary phase interferometric effects at the threat radar location. Existing retrodirective cross-eye techniques are inadequate to counter the RF agile threat due to propagation delays. Using modeling and simulation, the research shows …
Application Of A Finite-Volume Time-Domain Maxwell Equation Solver To Three-Dimensional Objects, Frederick G. Harmon
Application Of A Finite-Volume Time-Domain Maxwell Equation Solver To Three-Dimensional Objects, Frederick G. Harmon
Theses and Dissertations
Concurrent engineering approaches for the disciplines of computational fluid dynamics (CFD) and electromagnetics (CEM) are necessary for designing future high-performance, low-observable aircraft. A characteristic-based finite-volume time-domain (FVTD) computational algorithm, developed for CFD and now applied to CEM, is implemented to analyze the radar cross section (RCS) of two three-dimensional objects, the ogive and cone-sphere. The FVTD formulation implements a Monotone Upstream-Centered Scheme for Conservation Laws (MUSCL) algorithm for the flux evaluation and a Runge-Kutta multi-stage scheme for the time integration. Developmental FVTD work for the thesis focused on algorithm development to analyze scattering and obtain RCS data for closed-surface perfect …
Experimental Investigation Of Radar Cross Section Spatial Correlation Properties For A Point Scattering Target, John D. Shannon
Experimental Investigation Of Radar Cross Section Spatial Correlation Properties For A Point Scattering Target, John D. Shannon
Theses and Dissertations
This research investigates the spatial correlation of RCS. In pulsed radar systems, probability of detection for partially correlated signals depends on the autocovariance of the target's RCS. The RCS changes pulse to pulse due to spatial and time fluctuations. Spatial fluctuation are due to the motion of all scatterers relative to the radar (i.e. changing aspect angle). Time fluctuations are due to relative motion of scatterers to each other (i.e. wings flexing, engines spinning). Theory developed at AFIT [9] can generate autocovariance estimates from a distribution of scatterers. Theory based autocovariance estimates are compared to static measurement based autocovariance estimates …
Evaluation Of The Sensitivity Of Radar Cross Section Predictions To Uncertainties In Material Characteristics, Greg A. Barnhart
Evaluation Of The Sensitivity Of Radar Cross Section Predictions To Uncertainties In Material Characteristics, Greg A. Barnhart
Theses and Dissertations
The purpose of this study was to evaluate the effects of material characteristics uncertainties on Radar Cross Section (RCS) predictions. Many methods have been developed to predict the RCS of metal objects, but for material coated objects, these methods depend on the accuracy of measured material characteristics. Material characteristics of three dielectrics were measured by two separate X-band waveguide set-ups. RCS measurements were then made to evaluate the accuracy of RCS predictions using these measured material characteristics. A six inch square slab of each material was measured with and without a metal plate backing. A six inch square flat metal …
Radar Cross Section Visualization Using Sample Buffer Progressive Refinement Volume Rendering, Alain L. Jones
Radar Cross Section Visualization Using Sample Buffer Progressive Refinement Volume Rendering, Alain L. Jones
Theses and Dissertations
This study developed a prototype for an interactive radar cross section visualization software system. The system, hosted on a Silicon Graphics workstation, is intended to support aircrews, mission planners, aircraft designers, and others who require an understanding of aircraft radar cross section characteristics. The input to the system is a set of radar cross section samples taken at various aspect angles. A pre-processor developed as part of this study transforms the input radar cross section data into a three-dimensional cuberille data volume. This data volume is then visualized using an interactive volume renderer. The interactive volume renderer implements progressive image …
Scientific Visualization Of Volumetric Radar Cross Section Data, Thomas G. Wojszynski
Scientific Visualization Of Volumetric Radar Cross Section Data, Thomas G. Wojszynski
Theses and Dissertations
For aircraft design and mission planning, designers, threat analysts, mission planners, and pilots require a Radar Cross Section (RCS) central tendency with its associated distribution about a specified aspect and its relation to a known threat, Historically, RCS data sets have been statically analyzed to evaluate a d profile. However, Scientific Visualization, the application of computer graphics techniques to produce pictures of complex physical phenomena. appears to be a more promising tool to interpret this data. This work describes data reduction techniques and a surface rendering algorithm to construct and display a complex polyhedron from adjacent contours of RCS data. …
Methods For Viewing Radar Cross Section Data In Three Dimensions, David J. Tisdale
Methods For Viewing Radar Cross Section Data In Three Dimensions, David J. Tisdale
Theses and Dissertations
Radar Cross Section data is an important factor in the design of modern fighter and bomber aircraft. Minimization of the reflected radar energy is one of the key issues when choosing shapes and materials in new aircraft. Visualization of the energy scattered back to a radar is neither intuitive nor easy. The mission planner and pilot need to gain an understanding of the vulnerabilities inherent in the design of the systems they use. The advent of relatively low cost graphics workstations has made their use affordable in applications inconceivable only a few short years ago. This thesis examines three graphics …