Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Electrical and Computer Engineering

Faculty of Engineering University of Malaya

Selected Works

2015

Implementation

Articles 1 - 2 of 2

Full-Text Articles in Engineering

Single Phase Transformerless Inverter Topologies For Grid-Tied Photovoltaic System: A Review May 2015

Single Phase Transformerless Inverter Topologies For Grid-Tied Photovoltaic System: A Review

Faculty of Engineering University of Malaya

Grid-tied inverters are the key components of distributed generation system because of their function as an effective interface between renewable energy sources and utility. Recently, there has been an increasing interest in the use of transformerless inverter for low-voltage single-phase grid-tied photovoltaic (PV) system due to higher efficiency, lower cost, smaller size and weight when compared to the ones with transformer. However, the leakage current issues of transformerless inverter, which depends on the topology structure and modulation scheme, have to be addressed very carefully. This review focuses on the transformerless topologies, which are classified into three basic groups based on …


An Improved Particle Swarm Optimization Based Maximum Power Point Tracking Strategy With Variable Sampling Time Jan 2015

An Improved Particle Swarm Optimization Based Maximum Power Point Tracking Strategy With Variable Sampling Time

Faculty of Engineering University of Malaya

This paper presents an improved maximum power point tracking (MPPT) strategy for photovoltaic (PV) systems based on particle swarm optimization (PSO). The capability of the PSO algorithm to cope with partially shaded conditions (PSCs) is the primary motivation of this research. Unlike conventional PSO-based MPPT systems, a variable sampling time strategy (VSTS) based on the investigation of the dynamic behavior of converter current is deployed to increase system tracking time. The performance of the proposed system is evaluated using MATLAB simulation and experimentation, in which a digital signal controller is used to implement the proposed algorithm on a real boost …