Engineering Commons^™

Traveling Wave Fault Location Method For Distribution Systems With Distributed Generation, Oluwafeyisayo Afolabi

Theses and Dissertations--Electrical and Computer Engineering

Fault location is an important topic within electric power systems, as accurate fault location techniques will improve the reliability of the system and reduce downtime caused by outages. This paper explores fault location in distribution systems with distributed generation using the traveling wave fault location method. The single-ended and double-ended traveling wave methods are evaluated using a single-circuit distribution system which is modeled using MATLAB SIMULINK. The results are compared using a basis of signals and bus pairs across fault types, sampling rates and fault resistances.

Advanced Fault Area Identification And Fault Location For Transmission And Distribution Systems, Wen Fan

Theses and Dissertations--Electrical and Computer Engineering

Fault location reveals the exact information needed for utility crews to timely and promptly perform maintenance and system restoration. Therefore, accurate fault location is a key function in reducing outage time and enhancing power system reliability.

Modern power systems are witnessing a trend of integrating more distributed generations (DG) into the grid. DG power outputs may be intermittent and can no longer be treated as constants in fault location method development. DG modeling is also difficult for fault location purpose. Moreover, most existing fault location methods are not applicable to simultaneous faults. To solve the challenges, this dissertation proposes three …

Fault Location In Transmission Systems Using Synchronized Measurements, Xiangqing Jiao

Theses and Dissertations--Electrical and Computer Engineering

Compared with conventional measurements from supervisory control and data acquisition (SCADA) system, phasor measurement units (PMUs) provide time-synchronized and direct measurements of phasors. The availability of synchronized phasor measurements can significantly improve power system protection and analysis. This dissertation is specifically committed to using synchronized measurements for estimation of fault locations in transmission systems.

Transmission lines are prone to various short-circuit faults. Accurate fault location is critical for rapid power recovery. Chapter 2 proposes a new fault location method based on sparse wide area measurements. One distinguishing feature of this method is its applicability to both transposed and untransposed transmission …

Fpga To Power System Theorization For A Fault Location And Specification Algorithm, Christina Yeoman

Theses and Dissertations--Electrical and Computer Engineering

Fault detection and location algorithms have allowed for the power industry to alter the power grid from the traditional model to becoming a smart grid. This thesis implements an already established algorithm for detecting faults, as well as an impedance-based algorithm for detecting where on the line the fault has occurred and develops a smart algorithm for future HDL conversion using Simulink. Using the algorithms, the ways in which this implementation can be used to create a smarter grid are the fundamental basis for this research. Simulink was used to create a two-bus power system, create environment variables, and then …

New Accurate Fault Location Algorithm For Parallel Transmission Lines, Pramote Chaiwan

University of Kentucky Doctoral Dissertations

Electric power systems have been in existence for over a century. Electric power transmission line systems play an important role in carrying electrical power to customers everywhere. The number of transmission lines in power systems is increasing as global demand for power has increased. Parallel transmission lines are widely used in the modern transmission system for higher reliability. The parallel lines method has economic and environmental advantages over single circuit. A fault that occurs on a power transmission line will cause long outage time if the fault location is not located as quickly as possible. The faster the fault location …